Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
27
Required components/tools:
ruler
!6DUAL INSTALLATION
A
4 Align the top cap of the second appliance flush with the central spacer and top cap of first
appliance (B).
5 Mark the step (C) of each alignment gauge based on the thickness of the door panel to be
installed to the door.
6 Align the marked steps of the gauges flush with the edges of the cabinetry side walls.
– Place a ruler on the steps of the alignment gauges to check if they are in line (D)
relative to the thickness of the door panel.
7 Check if the gaps between appliance and cabinetry side wall are even.
1 Roll the second appliance into the cabinetry side by side with the first appliance. (A)
2 Continue rolling the appliance into the cabinetry until the anti-tip bracket overlaps
[minimum 71/8” (180mm)] the back top surface of the appliance. (Refer to ‘Attach the anti-
tip bracket’).
3 Check the clearance between the floor and the feet. Ensure the rollers of the appliance can
roll freely on the floor.
D
C
B
Positioning and aligning the second appliance inside the cabinetry