Quick Start Guide

33
@0INSTALL DOOR PANELS
Attach the door handle
1 For Stainless steel door panel:

Remove the plastic plugs from handle holes (x4).

Align the handle to the holes and secure with M5x25
hex screws (A).
For Custom panels:

Fix the handle with M5x25 hex screws from the inner
edge of the panel.

Refer to ‘Custom door panel dimensions’ section
to ensure door handle does not interfere with side
attachment brackets.
Hang the door panel
2 Open the door and loosen the screws at both sides of
the door (do not remove) (B).
3 Hang the door panel with a small angle to the door by
locating the holes of the top bracket to the M8 studs
(C), and rotate the door panel down so that the side
attachment brackets slide onto the side screws of the
door. (D)
4 Screw the M8 washer and nut to the stud (E), and
re-tighten the side screws (B) to fix the door panel
(do not fully tighten). This will allow opening the door
without affecting adjustment of the door panel.
IMPORTANT!

The assembly of Fisher & Paykel (Stainless steel) door
panels and Custom door panels are outlined below.

Ensure to protect the finish of the Fisher&Paykel
Stainless steel door panels. Leave the protective film on
the panels when hanging. Remove the film only when
the installation is complete.

If using Custom door panels, ensure they are prepared
as per ‘Custom door panel dimensions’ section.
Required components/tools:

4x M5x25 hex screws (842292)

1x drill with 3/32” (2.55mm) bit

1x Phillips driver on battery drill

M4 hex key

1/2” (13mm) spanner
IMPORTANT!
We recommended to load the shelves in the
appliance door with weights to ensure an
accurate door panel gap width.
Weight recommendations:
– 18” Appliance: 22lbs (10kg)
– 24” Appliance: 33lbs (15kg)
– 30” Appliance: 44lbs (20kg)
A
D
B
E
C