User Guide
Table Of Contents
- User Guide
- Contents
- Safety and warnings
- Before you begin
- Control panel
- Burner use
- Care and cleaning
- Troubleshooting
- Warranty and service
- Guide d’utilisation
- Table des matières
- Consignes de sécurité et mises en garde
- Avant de commencer
- Panneau de commande
- Utilisation des brûleurs
- Entretien et nettoyage
- Dépannage
- Garantie et service
BURNER USE
Manual lighting
If there has been a power outage, the burners can be manually lit. If you have attempted
to light the burner with the ignition, allow 1 minute for any accumulated gas to dissipate
before manually lighting.
1
Carefully hold a battery operated lighter
near the desired burner.
When the burner is lit, turn the dial to any
setting between
HI (high) and SIM (simmer).
When you have finished cooking, turn the
dial clockwise back to
OFF.
If you are using LP gas, there may be
a slight extinction pop or flash at the flame
spreader a few seconds after the burner has
been turned off. This is normal.
2
3
4
Push the dial in and turn counterclockwise
to HI. Hold the dial at HI before turning to a
flame setting.
11