Installation and Operation Guide

11
INSTALLATION INSTRUCTIONS
Fastening the cooktop to the bench
1 Turn the cooktop upside down and place it on a soft surface.
2 Spread the seal around the edges of the ceramic glass with the adhesive side facing
down, making sure that the whole perimeter is sealed. Cut off any excess material.
3 Mount the supplied clamps (A) and screws (B) onto the cooktop, as shown (without
tightening the screws).
4 Place the cooktop into the cutout, then tighten the screws to clamp the cooktop
securely to the bench.
5 Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge
of the cooktop. Take care not to damage the benchtop.
Note: if your bench is thicker than 40 mm, recess the underside to between
30 and 40 mm.
Preparing the cooktop before installation (models may vary)
Fastening the cooktop to the bench
A
A
A
A
B
Seal
B
B
B
Adhesive side
30 mm min.
40 mm max.
A
B
Seal