,1) 3-500 1408 1200aCOSSLE Inscrutableness IN dd 508 11:14:50 AM Jet EGE IES imp SAVE [et le) rant! THESE INS INSTRUCT TONS m SAFETY AND WARNINGS PLT] Electrical shock hazard Disconnect product from the rains power supply before servicing. This appliance is equipped with a three-prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded power outlet, Do not under any Circumstances cut or remove the grounding prong from this plug.
| 11,2) 1SOGH4EE Alighieri Castellated IND GER 11:14:50 AM (2) PRODUCT & CUTOUT DIMENSIONS (3) CLEARANCE & CABINETRY DIMENSIONS stet Gas inlet nonce ti located in the back theft corner, WARNING! “The Cook Surface requires adequate air supply to fully function, The base of the Cook Surface must have direct unrestricted ventilation to the 100m where the Cook Surface is installed. Do not ventilate the base ares to an external area that can be at different aif precise to that of the burners.
|B) -1SD9H4EE 20naCABHGLS FSIAARUISCAINGD S508 11:14:50 AM (2) PARTS SUPPLIED ET NOTE 5 IMPORTANT INSTALLATION INFORMATION We do not recommend you flush mount or seal this appliance Into the counter with silicone or glue Doing 36 Will make Tutti Servicing difficult. Fisher & PayPal will not be label for ny casts associated with removing or replacing a sealed-in appliance, nor for repairing any damage that may be incurred by doing this.
|B) -DAUMIER Diaghilev FSIlAZUSCAIndd ISIDRO 111450 AM (6) FLUSH MOUNTING INSTALLATION (NOT RECOMMENDED) Sy View farm below nat recommend flush mounting and sealing as servicing requires the Subsurface to be removed from the counter top. ¥ The owner carries all isk for flush mounting the Cook Surface. The yawner must ensure the Look Surface has been cut aut k ¢ ; Refit existing from the counter top before rite v screw to secure i servicing can be carried out.
1,7) -25994488 i200 Hsu install (7) INSTALLATION Caddying G50 11:15:08 The Cock Surface requires adequate Piper function, The base of the Facebook must have direct unrestricted ventilation to the corm where tie Cook Surface is Installed. Do not ventilate the base area to an eternal area that can be at different als pressure to that of the burners. You may ventilate from licentiate cupboards, but ensure that the available alr supply will not be restricted.
Siu inst Caddying G50 11:45:08 Al (& CHECK FOR GAS LEAKS AND TEST [TE WHO Test operation by lighting all boomers,
| 2%) 3 5DGH4BE 20naCGHGLS steal Caddying G50 11:15:08 Al FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER Have you installed the clamping brackets? Have you allowed for adequate alr supply to the product? Have you leak-tested all connections? 1 lathe regulator set to the correct working pressure (ATH ONG/TT"H O LP)? Have you placed the supplied duplicate data plate an an adjacent surface? Is the Cook Surface grounded? Che that the power supply cable is NOT touching the Cocksure face.