Data Sheet Induction Cooktop

30'' INDUCTION COOKTOP
DATA SHEET
Model no:
CI304DTB2 (refer page 2 for metric measurements)
Product Dimensions
in
a Height of chassis including conduit junction (below countertop)
3 11/16''
B Overall width of cooktop
29 1/2''
c Overall depth of cooktop
20 7/8''
D Height from countertop datum to top of cooktop glass
3/16''
e Width of chassis
28 7/16''
f Depth of chassis
18 7/8''
g Depth of front control panel
3 3/8''
h Depth of cooktop cooking area
17 3/8''
i Distance from side edges of cooktop to chassis
9/16''
j Distance from front edge of cooktop to chassis
1/2''
k Distance from back edge of cooktop to chassis
1 7/16''
Minimum Clearances
in
Minimum clearance from side edges of cutout to nearest
combustible surface
1 3/16''
Minimum clearance from rear edge of cutout to nearest
combustible surface
1 3/16''
Minimum clearance from front edge of cutout to front edge of
counter
1 3/8''
Minimum clearance below top of countertop to:
Top of oven* installed below cooktop or cabinetry
Top of drawer or other obstruction below cooktop
4 1/8''
4 1/8''
Minimum clearance from glass surface to:
- overhead cabinet centered above the cooktop (unprotected)
- overhead cabinet centered above the cooktop (protected)
- rangehood
30''
24''
25 5/8''
Minimum clearance from glass surface to overhead cabinet not
directly above the cooktop
23 1/2''
Minimum ventilation gap between bottom of counter and top of
cabinetry fronts (not shown)
3/16''
*NOTE: The oven installed below the cooktop MUST have a cooling fan. It is important that the
induction cooktop receives adequate air supply. For ventilation requirements please refer to the
installation manual.
Cutout Dimensions
in
Overall width of cutout
28 3/4''
Overall depth of cutout**
19 5/16''
**Note cutout position is centered to the cooktop width, but offset to the cooktop depth.
Cutout front depth is 3/8'' from the front edge of the product.
INDICATES CUTOUT -------------------------------------------------------
INDICATES CABINETRY / PRODUCT DATUM -------------------------
INDICATES CABINETRY CLEARANCES --------------------------------
DATE: 28.08.2016
IMPORTANT NOTE: Throughout this guide, dimensions may vary by ±2mm
(3/32''). Please read the installation manual for detailed information on
installing the product. For full installation instructions & specifications visit
fisherpaykel.com
CLEARANCE : OVERHEAD CABINET (UNPROTECTED)
CLEARANCE : OVERHEAD CABINET (PROTECTED)
0 5 10 20
inches
20 7/8''
DATUM :
TOP OF BENCHTOP
29 1/2''
B
e
C
h
g
D
A
f
CLEARANCE : COMBUSTIBLE SURFACE
FRONT VIEW
PLAN VIEW
PROFILE VIEW
CLEARANCE : OVEN OR CABINETRY
CLEARANCE : RANGEHOOD
i i j k
CLEARANCE : OVERHEAD CABINET
NOT DIRECTLY ABOVE COOKTOP
CONDUIT JUNCTION CONDUIT JUNCTION