INDUCTION COOKTOP CI304PTX & CI365PTX models INSTALLATION GUIDE US CA 591351 A 06.
1
1 ! SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING! Electrical shock hazard Disconnect the appliance from the mains electricity supply before carrying out any work or maintenance on it. Connection to a good earth wiring system is essential and mandatory. Alterations to the domestic wiring system must only be made by a qualified electrician. Failure to follow this advice may result in electrical shock or death. ● ● ● ● ● ! WARNING! Cut Hazard Take care - panel edges are sharp.
3 PRODUCT & CABINETRY DIMENSIONS J B Note: Electrical connection is at the center rear K C L PLAN PLAN B A C D FRONT I E FRONT PROFILE I G F H Conduit Junction CI304PTX CI365PTX INCHES (MM) INCHES (MM) 3 5/16” (84) 3 5/16” (84) B Overall width of cooktop 30” (762) 36” (914) C Overall depth of cooktop 21” (533) 21” (533) PRODUCT AND CABINETRY DIMENSIONS A Height of chassis (below top of benchtop)(incl.
4 CLEARANCE DIMENSIONS min. 3/16” (4 mm) F H G B A C E H D Drawer or other obstruction Alternatively 2x 2” (50mm) holes in side wall to allow adequate cool air J I H min.
5 DISCARD PACKAGING Recycle responsibly 6 5 LOWER GENTLY INTO THE CUTOUT
CONNECTING THE COOKTOP TO THE MAINS POWER SUPPLY IMPORTANT! ● ● ● This cooktop must be connected to the mains power supply only by a suitably qualified person. To connect the cooktop to the mains power supply, do not use adapters, reducers, or branching devices, as they can cause overheating and fire. The power supply cable must not touch any hot parts and must be positioned so that its temperature will not exceed 165 oF / 75 oC at any point.
!0 FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER Have you demonstrated the basic operation to the customer? Is the cooktop earthed? Check that there is an adequate and constant flow of cool air from the cabinetry to the base of the cooktop. Check that the power supply cable is not accessible via cupboard doors or drawers and that it is NOT touching the cooktop.
8
SURFACE DE CUISSON À INDUCTION Modèles CI304PTX et CI365PTX GUIDE D’INSTALLATION US CA 591351 A 06.
1
1 ! CONSIGNES DE SÉCURITÉ ET MISES EN GARDE Risque de choc électrique Déconnectez l’appareil de l’alimentation électrique avant de procéder à tout travail d’entretien ou de maintenance sur celui-ci. La connexion à un système de mise à la terre convenable est essentielle et obligatoire. Les modifications au système de câblage domestique doivent être effectuées uniquement par un électricien qualifié. Le non-respect de cette consigne peut entraîner un choc électrique ou la mort.
3 DIMENSIONS DU PRODUIT ET DES ARMOIRES B J Remarque : Le raccordement électrique s’effectue à l’arrière, sur le côté droit K C L DESSUS DESSUS B A C D CÔTÉ AVANT I AVANT conduit jonction E I DIMENSIONS DU PRODUIT ET DES ARMOIRES A Hauteur du châssis (ci-dessous haut de la surface de paillasse)(incl.
4 DIMENSIONS DE DÉGAGEMENT min. 3/16” (4 mm) F H G B A C E H D Drawer Tiroir or ouother autreobstruction obstacle Ou encore, Alternatively 2 ouvertures 2x 2” (50mm) holes deside Ø 2”wall (50 mm) in dans la paroi pour to allow adequate permettre que cool air l’air frais circule convenablement J I H min.
5 METTEZ L’EMBALLAGE AU REBUT Recyclez de façon responsable 6 5 DÉPOSEZ L’APPAREIL DOUCEMENT DANS L’OUVERTURE
7 RACCORDEMENT DE LA SURFACE DE CUISSON À L’ALIMENTATION ÉLECTRIQUE IMPORTANT! ● ● ● ● ● ● Schémas de raccordement Cette surface de cuisson doit être raccordée à l’alimentation électrique uniquement par une personne qualifiée. Pour raccorder la surface de cuisson à l’alimentation électrique, n’utilisez pas d’adaptateurs, de raccords réducteurs ou de dispositifs de branchement, car ils pourraient causer une surchauffe et un incendie.
!0 LISTE DE VÉRIFICATION FINALE À ÊTRE REMPLIE PAR L’INSTALLATEUR Avez-vous expliqué le fonctionnement de base au client? La surface de cuisson est-elle mise à la terre? Assurez-vous que l’air frais circule convenablement entre les armoires et la base de la surface de cuisson.