DOWNDRAFT INDUCTION COOKTOP MINIMAL CID834DTB4 INSTALLATION GUIDE NZ AU UK IE SG
SAFETY AND WARNINGS WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • Disconnect the appliance from the mains electricity supply before carrying out any work or maintenance. • Connection to a good earth wiring system is essential and mandatory. • Alterations to the domestic wiring system must only be made by a qualified electrician. WARNING! Cut Hazard Failure to use caution could result in injury. • Take care: some edges are sharp.
INSTALLATION CONSIDERATIONS BEFORE INSTALLATION Please ensure the following: z z z z z z z z z z z 4 A suitable disconnection switch is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. A means of disconnection with at least a 3mm air gap contact separation in all poles must be incorporated into the fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for alternative means.
TOOLS AND COMPONENTS PARTS SUPPLIED z z z OPTIONAL ACCESSORY KITS Keep all packing materials until the unit has been inspected. Inspect the product to ensure there is no shipping damage. If any damage is detected contact the dealer or retailer you bought the product from to report the damage. Fisher & Paykel is not responsible for shipping damage.
PRODUCT DIMENSIONS b o r h q c d PLAN k f REAR (DUCTING REMOVED) l i g j e PRODUCT DIMENSIONS MM A Overall height of cooktop 218 B Overall width of cooktop 830 C Overall depth of cooktop* 529 D Depth of cooktop surface 515 E Height of chassis 50 F Width of chassis 799 G Depth of chassis 488 H Height of glass** 6 I Depth of front overhang of cooktop glass** 13 J Depth of rear overhang of cooktop glass** 13 K Depth of left overhang of cooktop glass** 15 L Depth of right o
OPTIONAL ACCESSORY DIMENSIONS HORIZONTAL ELBOW VERTICAL ELBOW ACCESSORY DIMENSIONS MM Horizontal Elbow (82390: E90-H-222-89) c d e a b 93 B Overall width of horizontal elbow 287 C Overall depth of horizontal elbow 287 Vertical Elbow (82391: E90-V-222-89) f DUCTING A Overall height of horizontal elbow CONNECTOR D Overall height of vertical elbow 174 E Overall width of vertical elbow 226 F Overall depth of vertical elbow 174 Ducting (part of kit 82389: D1-C-222-89) G Overall height of du
CUSTOM DUCTING OPTIONAL RECIRCULATION KIT* If using custom ducting, refer to the cooktop outlet dimensions below. To connect cooktop to round ducting, accessory kit DA-219-98-150 can be purchased separately. Accessory kit KRCID834 can be purchased separately to allow for recirculated venting.
CUTOUT PROUD INSTALLATION FLUSH INSTALLATION B c A F B C D E G d H PLAN PLAN A FRONT FRONT CUTOUT DIMENSIONS MM A Overall width of cutout 807 B Overall depth of cutout 492 C Minimum depth at rear 50 D Corner radius of cutout max 10 CUTOUT DIMENSIONS MM A Overall height of routered recess* 6 B Overall width of routered recess 835 C Overall depth of routered recess 520 D Overall width of cutout 807 E Overall depth of cutout 492 F Minimum depth at rear 50 G Corner radius
CLEARANCES CLEARANCE DIMENSIONS d MM A Minimum clearance from cook surface to: f Unprotected overhead cabinet centered above cooktop*† 650 Protected overhead cabinet centered above cooktop*† 500 B Minimum clearance below countertop** 415 C Minimum clearance from side of cutout to nearest adjacent combustible surface 40 z c z c D Maximum depth of combustible overhead cabinetry 330 E Minimum distance between overhead cabinets (centred above cooktop) 830 F Minimum clearance from rear of cu
VENTING PREPARATION VENTING TO THE REAR Through same cabinetry z z z This can be acheived using the supplied components. When ducting is centred below cooktop, a maximum venting height of 1067mm* is possible, alongside a maximum venting depth of 93mm***. These distances can be extended by using accessory kit D1-C-222-89. When ducting is directly below the outlet, a maximum venting height of 847mm* is possible, alongside a maximum venting depth of 93mm***.
ELECTRICAL CONNECTION CONNECTION LOCATION SINGLE-PHASE CONNECTION 220-240V~ Before connecting the cooktop to the mains power supply check that: z z z The domestic wiring system is suitable for the power drawn by the cooktop. The voltage corresponds to the value given in the rating plate. The power supply cable sections can withstand the load specified on the rating plate. CONNECTION Single-phase MAX. CURRENT DRAW MAX.
INSTALL DUCTING Fit the 90° elbow to the cooktop outlet. Tape to secure. 1 2 If ducting direct from the outlet, the 90º elbow is not required however the connector from accessory kit D1-C-222-89 must be used. Cut all other ducting to required lengths and slot together. Tape to secure.
INSTALL COOKTOP – PROUD Turn the cooktop upside down on a protective cover. 1 Attach the four side clips to the cooktop chassis. 4 Ensure the clips are oriented correctly. Elbow Ducting Apply adhesive foam seal around the glass overhang, 5mm from the edge of the glass. 2 Ensure the adhesive side facing is down to form a continuous seal around the cooktop. 5mm 3 14 Trim the excess sealing material using a sharp cutter or trimmer knife. Take care not to damage the benchtop.
INSTALL COOKTOP – FLUSH 1 Prepare the countertop for flush installation. Use a router to cutout the edges of the countertop to specified depth (6mm). Ensure all bare edges are sealed. Refer to 'Installation considerations'. adhesive 4 Apply silicone in the gap between countertop and cooktop. Wipe off any excess silicone. Attach an adhesive tape along the edges of the routered recess. Attach the four side clips to the cooktop chassis. 2 Ensure the clips are oriented correctly.
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER GENERAL VENTILATION Read safety and warnings in the user guide before operating the cooktop. Ensure all ducting components are taped securely. Specified clearance maintained. Check outlets are clear and not obstructed. Unit is level – front to back and side to side. All packaging materials have been removed. ELECTRICAL Receptacle with correctly rated over-current protection is provided for service cord connection.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2021. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
