FISHER & PAYPAL OVER THE RANGE CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS Please read all Instructions thoroughly before installing the Over the Range Microwave Oven/Hood System. Two people are recommended to install this product, # anew electrical outlet is required, its installation should be completed by a qualified electrician before the microwave oven Is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS seepage 2. 1.
3. ELECTRICAL GROUNDING INSTRUCTIONS This appliance must be grounded. This microwave oven is equipped with 2 cord having a grounding wire with a grounding plug. must be plugged inch a wall receptacle thatch properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances, {ri the event of an electrical short drought, grounding reduces isk of electric shock by providing an escape wire for the electric current.
5. TOOLS RECOMMENDED FOR INSTALLATION + Phillips Screwdriver + 112 Wood Bit or Metal Hole Cutter 0f metal cabinet Is used) + Electric Dill + HZ 5/8" and 3/32" Drill Bits © Scissors © Saw to cut exhaust opening (if needed) + Pencil + Measure » Tape Protective Drop Cloth for product and may also use carton for protection 6.
8. VENTILATION SYSTEM This Microwave Handwoven System is desired for adaptation to thees types of hood ventilation systems. Select the configuration required for your installation. A. Recirculating Non-Vented, Ductless Operation The writ is shipped assembled for reinoculating. Notes: 1. The Exhaust Darner Assembly (Figure 11 is oot required for recirculating operation, 2. The Charcoal Filter, located behind the hood exhaust louver, should be replaced every 6 to 12 months, depending on we. B.
C, Vertical Exhaust — Outside Ventilation 1. Remove and save the 4 screws from the Fan Cover Bracket, Hematite Fan Cover Bracket by sliding tin the opposite direction of the arrow on the Fan Cover Bracket as shows din Figure 12, 2 Lifter Hood Fan Unit carefully and slip wires out of cavity, Ses Figure 13. CAUTION: Do not pull or stretch hood fan wiring.
9. OVEN INSTALLATION THIS MICROWAVE OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES, READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES, MOUNTING PLATE 1. Separate 4 Toggle Bolts (2), packed in the INSTALLATION HARDWARE, from the Toggle Nuts. 2. Use Ward Screws (4) to attach Mounting Plate to the stud or studs. Use Toggle Bolts to attach Mounting Plate through the holes at AB, Can Dp UNLESS THOSE HOLES ARE LOCATED ON THE STUD.
MOUNTING OVEN STONEWALL Tyre people are recommended to attach the Microwave Oven/Hood to the Mounting Plate. 1. Thread the power supply cord through the hole made in the bottom of the top cabinet. 2. Hang the oven on the lower edge of the mounting plate. Rotate the unit upward. See Figure 20. Take cave that the power cord js able to clear the edge of the hole haste over is rotated upwind, {in the case of a nor-recessed cottony in the top cabinet, the hole for the cord may need to be enlarged) .
MOUNTING DEFLECTOR Secure the deflector with 3 Tapping screws packed in the Installation Hardware, Hw a Deflector © ! CHECKLIST FOR INSTALLATION 1. Make sure the unit has been installed according to all of the Installation Instructions and the Wall and Top Cabinet Templates. 2. Plug in the power cord, 3. Keep the use and care guide. FISHER & PAYPAL Fisher f PayPal Appliances, Inc. S800 Shekels Road, Huntington Beach CA $2847 Customer Cares BERORG.