Installation Manual

18
90°
2
1
90°
Pressure regulator installation
All heavy duty, commercial type cooking equipment must have a
pressure regulator on the incoming service line for safe and efficient
operation, since service pressure may fluctuate with local demand.
●
The regulator supplied with this range must be installed before
any gas connections are made.
●
Use supplied pressure regulator only.
!7GAS CONNECTION
1 Connect the 1/2” (12.7mm) NPT (conical) male connector
to the pressure regulator and tighten by using a wrench.
Do not over tighten the connector.
Over tightening may crack regulator.
2 Connect the 1/2” (12.7mm) NPT connector and pressure regulator
group to the extension pipe ensuring the supplied gasket is
positioned between.
The regulator cover must be oriented toward the front side of
the range.
3 Insert the extension pipe into the supplied support
bracket as shown:
●
Bend in the metal tab 90 degrees to allow the pipe
to be fitted into the bracket.
●
Bend the metal tab back into it’s original position
to secure.
Arrow
Gasket
Arrow
Regulator cover
IMPORTANT!
Use two wrenches to tighten the connection.
Regulator cover
Lock