User Manual

10
USING THE COOKTOP BURNERS
1 Identify the knob of the burner
you want to use.
3 When the burner has lit, turn the knob
to any setting between HI (high) and
SIM (simmer).
●
The clicking should stop as soon
as the burner has lit.
●
If the burner doesn’t light, and/or
the clicking doesn’t stop, or the
flames are not blue and well-defined,
turn the knob clockwise back to OFF
and see ‘Troubleshooting’ for advice.
4 When you have finished cooking,
turn the knob clockwise back to OFF.
●
The knob will release and the burner
and halo will go out.
●
If you are using LP gas, there may be
a slight ‘extinction pop’ or flash at
the flame spreader a few seconds
after the burner has been turned off.
This is normal for LP gas.
2 Push the knob in and turn it
counterclockwise to LITE.
●
Make sure you stop at LITE before
turning the knob to any flame setting.
●
The halo will glow orange.
●
You will start hearing a clicking sound.
If there is no clicking, turn
the knob clockwise back to OFF
and see ‘Troubleshooting’ for advice.
Halo
(Orange)
Halo
(Unlit)
Halo
(Orange)