Installation Guide

2
2 PARTS SUPPLIED
Clamp (1)
(for securing
Drain hose joiner)
Wire clip (1)
(for securing
Drain hose joiner)
Phillips
16 mm
screws (7)
38 mm
bottom fixing
screws & metal
washers (2)
Drain hose
support (1)
Moisture protection tape (1)
(to prevent moisture damage
to cabinetry)
Cavity Bracket Kit (1)
(supplied with Tall Height
Modelsonly)
(fitted before installation in order
to conceal the gap at the top of
the cavity left after installation.)
Drain hose
joiner (1)
Top
mounting
brackets (2)
OPTIONAL
Rubber washer for
inlet hose (1)
(comes already fitted)
Side mounting
bracket kit
(A and B) (2)
OPTIONAL
Edge Protector (1)
(If the services hole is through a
metal partition, the hole must be
protected with the Edge Protector
supplied to prevent damage to
the power cord or hoses.)
If the Drain hoses supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain
hoses by 11’ 10” (3.6m). The kit is available from the nearest Fisher & Paykel Authorized Service Center, or Toll free 1.888.936.7872 or www.fisherpaykel.com
External Venting kit (1)
Panel mounting
screws (6)
Panel bracket (1)
& Knock-to-Pause Module (1)
(shipped fixed to product)
DishDrawer™ Installation Video
This video provides an overview of what is needed to install a DishDrawer™. It is intended as an overview only of the installation process
and is not intended to be used as a guide on how to install a DishDrawer™ yourself. https://vimeo.com/325297597