Installation Guide

As you push product in, pull through hoses and cord, ensuring

they don’t get kinked or twisted.

IMPORTANT!

If product cannot be pushed in far enough, pull out again and

rearrange hoses and cord. Do not use excessive force, as doing

so may squash the hoses and lead to incorrect operation.

Open the

drawer halfway.

Using a flat

bladed

screwdriver,

prise the gray

rubber plug out

of the trim

moulding.

Replace the gray

rubber plug back into

the trim moulding

and ensure the trim

seal is facing forward.

Repeat for all

four brackets.

Using a small Philips

screwdriver, screw

through the trim

moulding, securing the

side mounting bracket

to the cabinetry.

Do not damage the

rubber trimseal.

!4-A SECURE TO THE CABINETRY ON THE SIDES!3-A PULL THROUGH HOSES & MOVE INTO THE CAVITY

!5-A SECURE THE EXTERNAL VENT

Vent hose either through same cabinet or

adjacent cabinet as per Step 7b or 7c

After routing the vent hose through

and out the hole cutout, attach and

secure the vent by tightening the

four screws provided.

Air flow