Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Plumbing & electrical considerations
- Hard-wiring (optional)
- Preparation
- Push the product into the cavity
- Fit custom door panels
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Install pre-finished toe kick
- Install custom toe kick
- Plumbing & electrical connection
- Installer checklist
- Troubleshooting
12
PREPARATION
SERVICE ACCESS
REAR
WALL
REAR
WALL
INSIDE
WALL
FLOOR
PLAN
PROFILE
SERVICE HOLE DIMENSIONS INCHES MM
A Maximum distance between rear of cavity and service hole 1/4 5
B Maximum distance between floor and service hole 1/2 10
C Minimum diameter of hose service hole 2 1/4 57
D Maximum diameter of power cord service hole 1 1/2 38
A
B
D
C
C
z
We recommend locating the service holes on either side of the DishDrawer™ Dishwasher as
shown below.
z
If the holes are created through wood, ensure the edges are smooth and rounded
z
If the holes are created through metal, ensure the supplied edge protector is fitted.
z
Ensure power cord is routed through a separate service hole to the hoses.
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris
before carefully applying the tape to
the surface.
1
MOISTURE PROTECTION
3/8"
(10mm)
For best results, we recommend installing the supplied sound seal to reduce the possibility of
any excess noise occurring during daily use.
SOUND SEAL (OPTIONAL)
1
2
Cavity height of 34 – 34 7/16"
(864 – 874mm)
Lay the sound seal flat, do not fold.
Cavity height of 34 7/16" + (874mm +)
Fold the sound seal as illustrated.
Gently tilt the DishDrawer™ Dishwasher
back and align the seal to the front feet.
Carefully lower product and ensure seal
is still positioned correctly.
Hole
location
created
to suit
cabinetry