Installation Guide

18
!7 INSTALLING CUSTOM FRONT DRAWER PANELS
!7-E CONNECT THE KNOCK-TO-PAUSE MODULE
TO THE CONTROLLER
!7-G ATTACH CUSTOM PANEL TO PRODUCT
!7-F RECONNECT THE GROUND WIRE TO THE
PANEL BRACKET
!7-H ADJUST CUSTOM PANEL HEIGHT TO
ALIGN CABINETRY GAPS
2
2
1
Controller
Ensure the Knock-To-Pause Module
Cable is connected to the UI1 Port.
Electrical Shock Hazard
WARNING!
To earth the panel bracket, connect the earth
wire from the product to one of the tabs.
Any custom metal component (e.g. handle)
that extends past the rubber seal must be
earthed too.
Failure to follow these warnings may result
in electrical shock, injury or fire.
Reconnect the
Ground Wire to the
Panel bracket.
+ or -
1/16” (2mm)
Push the Custom Panel on to
the drawer and reinsert the
side pins on each side.
With the front panels fitted, insert
an appropriately sized Philips
screwdriver into the hole above the
side pin and rotate the panels up or
down to align the gaps
in your cabinetry.
Repeat on the other side if necessary.
Each panel has a maximum travel of
1/16” (2mm) up or down.
IMPORTANT!
Ensure that you maintain a minimum
of 1/16” (2mm) ventilation gap
below the panel.
IMPORTANT!
Ensure the rubber seal between the drawer
and panel is kept in place.
Side Pin