Planning Data Sheet

DATA SHEET
24" Single DishDrawer™ Panel Ready Tall
INDICATES CABINETRY / PRODUCT DATUM -------------------------
INDICATES CABINETRY CLEARANCES --------------------------------
DATE: 28.05.2018
IMPORTANT NOTE: Throughout this guide, dimensions may vary by ±2mm (1/16'').
Please read the installation manual for detailed information on installing the
product. For full installation instructions & specifications visit fisherpaykel.com
0 5 10 20
inches
DATUM : BOTTOM OF CARCASS
DATUM : FRONT OF CARCASS
DATUM : FRONT OF CARCASS
23 9/16"
B
23 9/16"
B
21 3/4"
C
17 7/8"
A
FRONT VIEW
PLAN VIEW
PROFILE VIEW
D
D
C
Model no:
DD24STI9_N
DD24SHTI9 _N
(refer page  for metric measurements)
Product Dimensions
in
a Overall height* of DishDrawer™
17 7/8"
B Overall width* of DishDrawer™
2 9/16"
C Depth of DishDrawer™ chassis*
21 /4"
D Depth of drawer (open) (measured from front datum)*
20 /4"
* Does not include the custom drawer panel or handle to be manufactured
and fitted by cabinetmaker.
Note: Service outlet at rear extends both sides, hoses and cords can be routed
to either or both.
Minimum Clearances
in
Minimum inside height of cavity from bottom datum**
18"
Minimum inside width of cavity
2 5/8"
Minimum inside depth of cavity from front datum
22 1/16"
Minimum height of ventilation gap under custom drawer panel
with external venting kit installed
1/16"
Minimum gap from top of custom drawer panel to bottom of
benchtop
1/16"
Minimum clearance from a corner cupboard
1/2"
** This Dishdrawer™ has also been designed to fit a 18 7/8" high cavity.
For full details please refer to the installation manual.
NOTE: If using External Venting Kit and venting into the toekick area, a
minimum toekick height of 4" is required to prevent pooling of condensation.
CLEARANCE :
CORNER CUPBOARD
CLEARANCE :
CORNER CUPBOARD