Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Clearances
- Plumbing & electrical considerations
- Hard wiring (optional)
- Cabinetry preparation
- External venting preparation
- Fit the trim bracket
- Prepare external venting
- Push the product into the cavity
- Secure the venting hose to cabinetry
- Fit the custom panel
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Installer checklist
- Troubleshooting
13
CABINETRY PREPARATION
1
SERVICE ACCESS MOISTURE PROTECTION
REAR
WALL
SHELF*
PROFILE
SERVICE HOLE DIMENSIONS INCHES MM
A Maximum distance between rear of cavity and service hole 3/16 5
B Maximum distance between shelf* and service hole 3/8 10
C Minimum diameter of service hole 2 1/4 57
D If venting through the adjacent cabinetry, the rear edge of the service hole should be
enlarged by cutting out the bottom corner
*For assisted opening installations, maximum distance should be referenced from the top of the spacer blocks
A
B
C
D
z
Service holes can be created on either side of the DishDrawer™ Dishwasher cavity as
shown below.
z
If the hole is created through wood, ensure the edges are smooth and rounded
z
If the hole is created through metal, ensure the supplied edge protector is fitted.
3/8"
(10mm)
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris
before carefully applying the tape to
the surface.