Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Clearances
- Plumbing & electrical considerations
- Hard wiring (optional)
- Cabinetry preparation
- External venting preparation
- Fit the trim bracket
- Prepare external venting
- Push the product into the cavity
- Secure the venting hose to cabinetry
- Fit the custom panel
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Installer checklist
- Troubleshooting
15
FIT THE TRIM BRACKET PREPARE EXTERNAL VENTING
2
Check the trim seal is facing forward
and sitting flat under the bracket.
1
Align the bracket to the chassis ensuring
the arrow is facing forward and firmly
slot the tabs into place to secure.
Ensure the ends of the tabs are not
pushed into the chassis.
Rotate the elbow at the rear of the
product to either the left or right
depending on your venting location.
Push the vent hose onto the elbow
firmly to secure.
We recommend fitting the trim bracket when installing your DishDrawer™ Dishwasher into a
18 7/8" (480mm) cavity to conceal any visible gap left between the countertop and chassis.
FIT THE VENTING HOSE TO THE DISHDRAWER™ DISHWASHER
TRIM THE DUCT
On a protected surface, carefully cut
and remove the clips from the vent as
shown. Refit the top cover.
Unscrew the top cover from the vent
and set aside.
2
2
1
1
Framed cabinetry only
elbow