Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Clearances
- Plumbing & electrical considerations
- Hard wiring (optional)
- Cabinetry preparation
- External venting preparation
- Fit the trim bracket
- Prepare external venting
- Push the product into the cavity
- Secure the venting hose to cabinetry
- Fit the custom panel
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Installer checklist
- Troubleshooting
16
If securing via bracket method:
Secure all four side brackets to the
DishDrawer™ Dishwasher, aligning
bracket A with slot A and bracket B
with slot B.
Ensure the ends of the brackets are not
pushed into the chassis.
Route the venting hose through
the floor. Ensure any excess hose
is removed.
Unframed cabinetry
Route the venting hose to the cutout
and push onto the duct firmly to secure.
Push the duct onto the cabinetry and
secure using the four provided screws.
Framed cabinetry
Route the venting hose to the cutout
and push onto the duct firmly to secure.
Place duct into cutout and insert the
bracket into vent slot. Secure using the
five provided screws.
1
2
Push the product into the cavity, pulling
the hoses through as you push to avoid
crushing or twisting them.
PUSH THE PRODUCT INTO THE CAVITY SECURE THE VENTING HOSE TO CABINETRY
VENTING THROUGH FLOOR
VENTING THROUGH CABINETRY
A
A
B
B