Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Clearances
- Plumbing & electrical considerations
- Hard wiring (optional)
- Cabinetry preparation
- External venting preparation
- Fit the trim bracket
- Prepare external venting
- Push the product into the cavity
- Secure the venting hose to cabinetry
- Fit the custom panel
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Installer checklist
- Troubleshooting
18
SECURE TO CABINETRY VIA BRACKETS (METHOD A)
Secure to cabinetry via the brackets.
Pre-drilling a pilot hole may be required
depending on the cabinetry material.
2
3
Replace the trim cover and repeat for
the remaining brackets.
SECURE TO CABINETRY VIA DRAWER REMOVAL (METHOD B)
Secure to cabinetry via all three
fixing locations in the tub.
Ensure sound insulation is
replaced correctly.
3
1
2
4
Before refitting the drawer, ensure the
hoses are not twisted.
Refit the drawer to the runners and clip
into place via both locking tabs.
Partially open the drawer and remove
the first screw cover from the
trim moulding.
1
Open the drawer and press both locking
tabs back to release.
Lift the drawer off the runners and
carefully set aside on a protected
surface. Push runners back in.
Take care not to pull drawer out
too far to prevent any strain on the
hoses. Where possible, protect the
base of the tub to prevent damage.
1 1/2" 38mm screw
and large washer