Installation Guide
Table Of Contents
- Safety and warnings
- Tools and components
- Product dimensions
- Custom panel dimensions
- Cabinetry
- Clearances
- Plumbing & electrical considerations
- Hard wiring (optional)
- Cabinetry preparation
- External venting preparation
- Fit the trim bracket
- Prepare external venting
- Push the product into the cavity
- Secure the venting hose to cabinetry
- Fit the custom panel
- Secure to cabinetry via brackets (method A)
- Secure to cabinetry via drawer removal (method B)
- Installer checklist
- Troubleshooting
20
Install your single Air Gap Kit to the
benchtop like shown.
Refer to ‘'Plumbing & electrical
considerations' for minimum
install heights.
Thread wire clip on to the hose before
securing the drain hose to the supplied
hose joiner and fit to the Air Gap Kit.
Ensure hose is routed straight to the
joiner, removing excess drain hose
if necessary.
Unplug or drill out the waste tee before
securing to sink trap or waste tee.
Plug product in.
SINGLE AIR GAP INSTALLATION
1
2
3
4
Connect the inlet hose to tap and hand-
tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
DishDrawer™ Dishwasher must be
powered on for the flood protection
feature to be enabled.
PLUMBING & ELECTRICAL CONNECTION