Data Sheet Integrated Single DishDrawer

DATA SHEET
600mm Integrated Single DishDrawer™
INDICATES CABINETRY / PRODUCT DATUM -------------------------
INDICATES CABINETRY CLEARANCES --------------------------------
DATE: 28.05.2018
IMPORTANT NOTE: Throughout this guide, dimensions may vary by ±2mm (1/16'').
Please read the installation manual for detailed information on installing the
product. For full installation instructions & specifications visit fisherpaykel.com
Model no:
DD60SI9, DD60SHI9
Dimensions
mm
a Overall height of DishDrawer™
410
B Overall width of DishDrawer™
599
c Overall depth of DishDrawer™
(assuming front panel thickness of 18mm)
571
D Depth of chassis
55
E Maximum extension of drawer from drawer front (excluding
handle)
527
F Depth of front panel*
16-20
g Height of front panel (recommended for a 2mm ventilation
gap below panel, if cavity height is 412mm)
408
h Minimum height of ventilation gap under custom drawer
panel with external venting kit installed
min 2
* Handle and custom drawer panel not included. To be supplied and fitted by
cabinetmaker.
Minimum Clearances
mm
Height of cavity
min 412
Width of cavity
600
Depth of cavity
min 560
Minimum clearance from a corner cupboard
1
NOTE: If using External Venting Kit and venting into the toekick area,
a minimum toekick height of 100mm is required to prevent pooling of
condensation.
Note: Service outlet at rear extends both sides, hoses and cords can be routed
to either or both.
599
B
571
A
FRONT VIEW
PLAN VIEW
PROFILE VIEW
D
e
g
f
h
e C
0 100 200 400
millimetres
410
DATUM : FRONT OF CARCASS
DATUM : FRONT OF CARCASS
DATUM : BOTTOM OF PRODUCT
553
CLEARANCE :
CORNER CUPBOARD
CLEARANCE :
CORNER CUPBOARD