Installation Guide

16
!4 INSTALLING CUSTOM FRONT DRAWER PANELS
2
3
2
16mm (x6)
4
1
1
2
16mm (x3)
!4-C ATTACH CUSTOM PANELS TO PANEL BRACKETS
There must be at least
3 screws used each side.
IMPORTANT!
O
Ensure the Knock-To-Pause
module is orientated correctly
before attaching.
O
Ensure the module is centralized
in the holes and not in contact
with the bracket.
Attach the Knock-To-Pause
module to the back of the custom
panel through the 3 holes cut into
the panel bracket as shown.
Use all 3 screws provided.
Repeat for the other module.
Align bottom of each custom panel
with the bottom of each bracket.
IMPORTANT!
Break off and discard the
tab at the top of the Lower
Panel Bracket.
!4-D ATTACH KNOCK-TO-PAUSE MODULES
TO CUSTOM PANELS