Data Sheet Integrated Single DishDrawer

DATA SHEET
600mm Integrated Single DishDrawer™ Tall
INDICATES CABINETRY / PRODUCT DATUM -------------------------
INDICATES CABINETRY CLEARANCES --------------------------------
DATE: 28.05.2018
IMPORTANT NOTE: Throughout this guide, dimensions may vary by ±2mm (1/16'').
Please read the installation manual for detailed information on installing the
product. For full installation instructions & specifications visit fisherpaykel.com
0 100 200 400
millimetres
DATUM : BOTTOM OF CARCASS
DATUM : FRONT OF CARCASS
DATUM : FRONT OF CARCASS
599
B
599
B
553
553
C
454
A
FRONT VIEW
PLAN VIEW
PROFILE VIEW
D
D
A
C
Model no:
DD60STI9, DD60SHTI9
Product Dimensions
mm
a Overall height* of DishDrawer™
454
B Overall width* of DishDrawer™
599
C Depth of DishDrawer™ chassis*
55
D Depth of drawer (open) (measured from front datum)*
527
* Does not include the custom drawer panel or handle to be manufactured
and fitted by cabinetmaker.
Note: Service outlet at rear extends both sides, hoses and cords can be routed
to either or both.
Minimum Clearances
mm
Minimum inside height of cavity from bottom datum
456
Minimum inside width of cavity
600
Minimum inside depth of cavity from front datum
560
Minimum height of ventilation gap under custom drawer panel
with external venting kit installed
2
Minimum gap from top of custom drawer panel to bottom of
benchtop
2
Minimum clearance from a corner cupboard
1
NOTE: If using External Venting Kit and venting into the toekick area,
a minimum toekick height of 100mm is required to prevent pooling of
condensation.
NOTE: This Dishdrawer™ has also been designed to fit a 480mm high cavity.
For full details please refer to the installation manual.
CLEARANCE :
CORNER CUPBOARD
CLEARANCE :
CORNER CUPBOARD