Installation Guide

12
INSTALLATION INSTRUCTIONS
Electrical connection information for electric dryers
For direct wire connections:
!
WARNING!
Fire Hazard
z
Use 10 gauge copper wire.
z
Use a UL-listed strain relief.
z
Disconnect power before making electrical connections.
z
Connect neutral wire (white or center wire) to center terminal.
z
Ground wire (green or bare wire) must be connected to green
groundconnector.
z
Connect remaining two supply wires to remaining two terminals.
z
Securely tighten all electrical connections.
z
Replace the terminal block cover.
z
Failure to do so can result in death, fire or electrical shock.
Grounding instructions
For a permanently connected dryer:
This dryer must be connected to a grounded metal, permanent wiring system, or
anequipment-grounding conductor must be run with the circuit conductors and connected
to the equipment-grounding terminal on the appliance.
WARNING!
Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician, or a Fisher&Paykel trained and
supported service technician if you are in doubt as to whether the appliance isproperly
grounded.
SAVE THESE INSTRUCTIONS