User Manual

8
INSTALLATION INSTRUCTIONS
Draining
The dryer is equipped with a condenser unit which
accumulates water during the drying cycle. This water is
collected in the removable water tank located at the top
left of the dryer. The accumulated water must be emptied
after each drying cycle. However you can also set up your
dryer to drain automatically using the drain hose provided.
Connecting the drain hose:
1
Remove the black drain hose from the connection at the
back of the dryer
A
and place it on the other connection
to the left
B
. Uncoil the white drain hose and connect it
to the back of the dryer where the black drain hose was
previously connected
C
.
2
Place the other end of the white drain hose into a tub or
standpipe. The connection between the dryer and the white
drain hose
C
must be secured to avoid a potential flood.
IMPORTANT!
If you connect the white drain hose onto your dryer and you do not secure the
other end in a drain, your dryer will drain water onto your floor. Ensure the drain
hose is securely fixed in place to an appropriate drain and is leak-free at the
connection to the machine.

Regularly check that your standpipe or tub is free from lint and other obstructions,
which may affect drainage and cause flooding.

The drain hose should be checked from time to time and replaced if any damage,
egwear, cuts, bulges, kinks, leaks, etc are found. Do not bend the drain hose sharply,
as this may cause it to split.

The extended length of the provided drain hose is 1.3m.

In multi-storey apartments or any upper floor, the machine should be installed on a
floor equipped with a drain.

Draining must comply with local by-laws.
A
Installing the drain hose
B
C