Installation Guide
Table Of Contents
INSTALLATION INSTRUCTIONS
13
ELECTRICAL
Volts 220–240
Hz 50
Amps (maximum) 10
Power consumption (W) 900
If you connect the drain hose onto your dryer, the other end must be secured in a drain to
prevent water draining onto the floor. Ensure the drain hose is securely fixed in place to an
appropriate drain and is leak-free at the connection to the machine. Check the connection
and drain hose regularly.
z
Maximum standpipe height is 1.0m from ground level.
z
Regularly check that your standpipe or tub is free from lint and other obstructions,
which may affect drainage and cause flooding.
z
The drain hose should be checked from time to time and replaced if any damage,
egwear, cuts, bulges, kinks, leaks, etc are found. Do not bend the drain hose sharply,
asthismay cause it to split.
z
The extended length of the provided drain hose is 1.3m.
z
In multi-storey apartments or any upper floor, the machine should be installed on
afloorequipped with a drain.
z
Draining must comply with local by-laws.
Electrical connection
z
This dryer must be connected to a 220V–240V,50Hz, sinusoidal, 10Aelectricalsupply.
z
Uncoil the power cord, remove and discard the plastic pin cover and plug into
a powersocket.
z
Connect the dryer to an earthed outlet protected by a fuse of suitable capacity.
z
Check the power cord for damage and make sure it is not squashed or twisted
wheninstallingthe dryer.
z
Always remove the power cord from the power socket by the plug, not by the cord.
SPARE PARTS* PART NO.
Foam filter kit 479832
Drain hose 479900
*Available from your Fisher&Paykel dealer or a Fisher&Paykel trained
and supported service technician.