Installation Guide
Table Of Contents
38
When a continuous series of beeps sound, all the lights turn off onthe control panel and a
number appears on the display, a fault hasoccurred. The dryer will automatically enter this
mode if a fault occurs. The word Fault will be shown in the control panel display followed
by a number. To stop the beeps, press any button then perform the following steps:
1 Turn your dryer off at the power point.
2 Wait one minute and turn it back on.
3 Check your dryer is installed correctly (refer to ‘Installation instructions’).
4 Remove your load from the dryer and retry.
5 Perform a
TIME DRY cycle, eg TIME DRY for 30 minutes.
6 If the fault re-occurs repeat steps
1
and
2
.
7 If the dryer still will not work call a Fisher & Paykel trained and supported
servicetechnician to arrange service (refer to ‘Customer care’). Recordthefaultcode
number displayed and the serial number of your dryer (locatedonthe rear of the
dryer, or on the insideof the door below the glass) beforecalling. The fault code will
indicateto the service technician what the problemcould potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing
POWER .
FAULT CODES