Installation Guide

42
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES WHAT TO DO
Noises Dryer is overloaded. Remove some items from the dryer.
Dryer has a fault. Continuous beeping or a musical
seriesof beeps with a message
displayed on the display.
Referto‘Fault codes’.
Beeps signalling the end
ofadrying cycle.
End of cycle beeps can be turned off
refer to ‘customising drying cycle’.
Dryer has not been
levelledproperly.
Refer to ‘Levelling the dryer’.
Dryer makes unfamiliar noises. At the start of the cycle the dryer may
make some unfamiliar noises when the
compressor turns on. Thisis normal.
Vibration Dryer is not installed on
astable surface.
Ensure the dryer is installed on a flat,
stable surface. Refer to ‘Levelling
the dryer’.
Dryer is not level. Ensure the dryer is correctly levelled.
Refer to ‘Levelling the dryer’.
Dryer is overloaded. Remove some items from the dryer.
Creasing Cycle selection not
appropriate for the load.
Select the
EASY IRON cycle to
minimisecreasing.
Dryer is overloaded. Remove some items from the dryer.
DRYNESS LEVEL selected
toohigh for load type.
Try selecting a lower DRYNESS LEVEL.
WRINKLE FREE option
notselected.
Select the WRINKLE FREE option to
rotate the load at the end of the
drying cycle. Refer to ‘Wrinkle Free’.