User Guide
Table Of Contents
- Safety and warnings
- Control panel
- WiFi connection
- Dry cycles
- Dry preparation
- Getting started quickly
- Drying cycle options
- Customising a dry cycle
- Caring for your dryer
- Before you call for service
- Fault codes
- Troubleshooting
- Energy consumption & cycle times
- Manufacturer’s warranty
- Customer care
- European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)
30
Emptying the water collection tank
During the drying cycle, steam condenses into water andis collected in the water tank,
located at the top left of the dryer. It is important to empty the water tank after every load.
Ifthewater tank becomes full during operation, thedryer will pause, display a user prompt
and beep to alert you.
Remove the water tank by holding onto
the handleand pulling outwards gently.
Ensurethe tank is kept level when removed
to prevent the water from spilling.
Never run the dryer without the water tank in place unless thedrainhosehasbeeninstalled.
You do not need to empty the water tank ifyou have set up the drain hose to drain the
waterautomatically.
1
2
Pour the water down the sink or into a
bucket, andthen put the tank back in place.
To empty the water tank:
CARING FOR YOUR DRYER