User Guide
Table Of Contents
- Safety and warnings
- Controls and starting a wash
- Setting Delay Start
- Setting wash modifiers (DW60FC6 and DW60UC6 models)
- Setting a 1/2 load (DW60FC6 and DW60UC6 models)
- User preference settings
- Caring for your dinnerware
- Loading advice
- Water hardness and dishwashing
- Wash programmes and detergent quantities
- Adding detergent
- Using rinse aid
- After the wash
- Care and cleaning
- Fault codes
- Troubleshooting
- Warranty and service
- Wash programme data
- Standards test (DW60FC1 models only)
- Standards test (DW60FC2 and DW60UC2 models only)
- Standards test (DW60FC4/C6 and DW60UC6 models only)
26
PROBLEM POSSIBLE CAUSE WHAT TO DO
Water marks
left on
glasses and
cutlery.
Rinse aid level or dosage
setting is too low.
Ensure there is rinse aid in dispenser. If
necessary, increase the rinse aid setting
or try using a wash programme with a
higher temperature. See sections ‘Using
rinse aid’ and ‘Wash programme data’.
Hard water Increase the rinse aid setting and the
amount of detergent. See section ‘Water
hardness and dishwashing’.
If living in an area with very hard
water, consult a plumber on installing a
household water softener.
TROUBLESHOOTING