Installation Guide

10
INSTALLATION INSTRUCTIONS
Installation
Your Fisher & Paykel refrigerator is fitted with frontand rear rollers,
designed for moving the product in the forwards and backwardsdirection.
Avoid moving the product in a sideways direction asthis may damage
the rollers or the floor covering/surface.
1
Your refrigerator will arrive with the front feet
woundup making moving the product into its
finallocation a simple task.
2
Roll the refrigerator into its final position
making surethere is the correct air gap
between the productand surrounding
cabinetry. See minimum clearance in cabinetry
dimensions table.
3
Adjust the front feet down until the
refrigerator is leaning backward with the front
approximately 10mm higher than the back.
This will ensure a good door closing action.
4
Aligning your refrigerator with cabinetry.
a Align the sides of the refrigerator with
the cabinetry by adjusting the hinge side
frontfoot.
b Adjust the handle side foot until it touches
the floor and takes a small amount
ofweight.
c Once the refrigerator is in place and
aligned with cupboards/alcove gently push
on the front top andcheck if the product
is rocking or stable.
Raise the front of
the refrigerator
Lower the front
of the refrigerator
Refrigerator feet