User Guide
26
FAULT CODES
If the dishwasher malfunctions, it will display a fault code and beep.
Check the following table below to see if you can correct the fault yourself.
FAULT
CODES AND
DESCRIPTIONS
POSSIBLE CAUSES WHAT TO DO
A20
Drain fault
Drain hose is crimped
or bent.
Check the drain hose and straighten
ifneeded.
The waste water is
notdraining out.
Ensure that the drain hose is connected in
accordance with the installation instructions.
The turbidity
sensor is dirty and
requirescleaning.
Gently clean the turbidity sensor with a soft
brush (ie toothbrush) to remove any buildup.
Turbidity sensor
A10
No water
Water tap not
turnedon.
Ensure the water is connected and turned on.
Touch to restart the dishwasher.
Insufficient water
supply pressure.
Check household water pressure.
Water inlet hose is
crimped or bent, sono
or not enough water
gets to the dishwasher.
Check the water inlet hose and straighten if
needed. Touch
to restart the dishwasher.
Drain hose is not
connected correctly.
Ensure that the drain hose is connected in
accordance with the installation instructions.