WALL RANGE HOOD, CHIMNEY PYRAMID CLASSIC HC24PCX1, HC30PCX1, HC30PCB1, HC30PCR1, HC30PCW1, HC36PCX1, HC36PCB1, HC36PCR1 & HC36PCW1 INSTALLATION GUIDE US CA
CONTENTS EN Safety and warnings 4 Parts supplied 6 Prior to installation 7 Product dimensions – 24" models 8 Product dimensions – 30" models 10 Product dimensions – 36" models 12 Installation height 14 Attachment dimensions 15 Venting options 16 Prepare range hood 18 Attach brackets and mounting screws 19 Hang range hood 20 Electrical connection 21 Attach chimney 22 Final checklist 23 Registration To register your product visit our website: fisherpaykel.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. • To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
SAFETY AND WARNINGS EN WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: z Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. z Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
PARTS SUPPLIED WALL RANGE HOOD, CHIMNEY PYRAMID CLASSIC HC24PCX1, HC30PCX1, HC30PCB1, HC30PCR1, HC30PCW1, HC36PCX1, HC36PCB1, HC36PCR1 & HC36PCW1 INSTALLATION GUIDE US CA Range hood (1) Upper chimney (1) Power connection box (1) Upper chimney bracket (1) Chimney bracket (1) 1 3/16" (30 mm) Expansion plug (10) 6 Installation guide (1) Chimney (1) 3/8" (10 mm) Self tapping screw (4) 1 3/16" (30 mm) Self tapping screw (10) 1 3/4"(44 mm) Drywall expansion plug (8)
PRIOR TO INSTALLATION EN The manufacturer is not liable for any damage caused by not following these instructions. z z z z z z Unpack the range hood. Ensure the voltage (V) and the frequency (Hz) indicated on the rating plate match the voltage and frequency of the installation site. Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes etc. The range hood surfaces can be damaged during installation if grazed or knocked by tools.
PRODUCT DIMENSIONS – 24" MODELS i j UL connection box h d PLAN g f A b e c PROFILE FRONT l k BOTTOM 8
PRODUCT DIMENSIONS – 24" MODELS PRODUCT DIMENSIONS EN HC24 IN MM A Maximum overall height of product 38 3/8 975 B Minimum overall height of product 25 1/16 636 C Overall width of product 23 9/16 598 D Overall depth of product 19 11/16 500 E Height of product 11 3/4 298 F Width of chimney 12 5/8 320 G Depth of chimney 11 7/16 290 H Distance from center of ducting outlet to back of product 4 5/16 110 I Distance from center of ducting outlet to side of chimney 6 5/16 160 J Diame
PRODUCT DIMENSIONS – 30" MODELS i j UL connection box h d PLAN g f A b e c PROFILE FRONT l k BOTTOM 10
PRODUCT DIMENSIONS – 30" MODELS PRODUCT DIMENSIONS EN HC30 IN MM A Maximum overall height of product 38 3/8 975 B Minimum overall height of product 25 1/16 636 C Overall width of product 29 3/4 755 D Overall depth of product 19 11/16 500 E Height of product 11 3/4 298 F Width of chimney 12 5/8 320 G Depth of chimney 11 7/16 290 H Distance from center of ducting outlet to back of product 4 5/16 110 I Distance from center of ducting outlet to side of chimney 6 5/16 160 J Diamet
PRODUCT DIMENSIONS – 36" MODELS i j UL connection box h d PLAN g f A b e c PROFILE FRONT l k BOTTOM 12
PRODUCT DIMENSIONS – 36" MODELS PRODUCT DIMENSIONS EN HC36 IN MM A Maximum overall height of product 38 3/8 975 B Minimum overall height of product 25 1/16 636 C Overall width of product 35 3/8 898 D Overall depth of product 19 11/16 500 E Height of product 11 3/4 298 F Width of chimney 12 5/8 320 G Depth of chimney 11 7/16 290 H Distance from center of ducting outlet to back of product 4 5/16 110 I Distance from center of ducting outlet to side of chimney 6 5/16 160 J Diamet
INSTALLATION HEIGHT A B HEIGHT DIMENSIONS A Ducted installation z Minimum height z Maximum hieght Recirculation z Minimum height z Maximum hieght B Height top of cooktop to base of product IN MM 25 1/16 636 38 3/8 975 26 5/8 676 38 3/8 975 26 – 30 660 – 762 This range hood must be installed no lower than the minimum height indicated in the table above. Minimum installation height may be greater if required by the cooktop, refer to your cooktop installation instructions.
ATTACHMENT DIMENSIONS H EN G Upper chimney bracket attachment points E Chimney bracket attachment points C F Upper range hood hood attachment points D Lower range hood attachment points B A ATTACHMENT DIMENSIONS IN MM A Lower range hood attachment point width 20 508 B Lower range hood attachment point height 1 3/4 45 C Upper range hood attachment point width 9 7/8 250 D Upper range hood attachment point height 11 1/4 286 E Chimney bracket attachment point width 9 7/8 250 F Chimn
VENTING OPTIONS Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. Ducted It is recommended that 8" (203mm) diameter, rigid or semi-rigid ducting is used. This will require a 8 1/4" (210mm) (min) round hole in the ceiling or wall. Care should be taken to position the hole correctly. For optimal efficiency use the shortest and straightest duct route possible and use rigid or semi-rigid ducting for reduced noise and increased airflow.
ELECTRICIAL REQUIREMENTS EN Rating plate location Before connecting the range hood to the power supply, ensure the voltage and frequency indicated on the rating plate match that of the installation location.
PREPARE RANGE HOOD Warning: Failure to install the screws or fixing device in accordance with these instructions may result in an electrical hazards. Remove the filters –pull the catch and tilt the filter downwards until it disengages from the supports.
ATTACH BRACKETS AND MOUNTING SCREWS EN Temporarily mark the height of the bottom of the range hood and the centre of the cooktop on the wall according to the information provided in 'Installation Height'. 1 Attach the chimney bracket and upper chimney bracket (if using the upper chimney). Use the 1 3/16" (30mm) screws and expansion plugs if attaching to masonry. 2 3 1/16" (2 mm) Attach the upper hood mounting screws. Use the 1 3/16" (30mm) screws and expansion plugs if attaching to masonry.
HANG RANGE HOOD 1 Hang the range hood off the upper range hood mounting screws with 1/16" (2mm) gap. Hang off the keyhole attachment points on the back of the range hood then tighten the screws. 2 Attach the lower range hood mounting screws to fix the range hood to the wall. Refit the filters. 3 20 Attach ducting to the ducting adapter using aluminium duct tape.
ELECTRICAL CONNECTION EN 1 Run three wires from the power connection box on the rangehood to the power point. 2 Two wires for the power supply and one for the ground wire. Open the power connection box on the range hood and secure the power conductor with a strain relief (not included). 3 Connect the power conductors to the conductors for the range hood, black to black and white to white. 4 Connect the grounding wire (green or bare) to the ground conductor (green) of the range hood power connection box.
ATTACH CHIMNEY 1 Bend the tabs on the chimney. REAR VIEW 2 Place chimney around the range hood chassis and hang off the chimney bracket. 3 Extend the upper chimney and attach to the upper chimney bracket with 10mm screws.
FINAL CHECKLIST EN TO BE COMPLETED BY THE INSTALLER Range hood is correctly installed and all connections are secure. Connections have not pierced any electrical or water lines within the wall. Ducting has not been crushed or bent in any area's. Flexible ducting has been pulled taut and any excess removed (if required). Power mains switch is accessible to the customer and switched on. Operation of the product has been tested, refer to user guide. Complete and keep for safe reference: Model Serial no.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2020. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
