User Guide

8
EN
Installation instructions
Assembly of chimney cover
1 Mark the wall at the location of support C (Fig.4a) according to the heights and specifications
shown on the mounting template.
9.84”
25”
7”
0.92”
9.84”
10.4”
10.26”
MIN 25.98”
Fig.3 Mounting template
2 Drill holes in the wall, place anchors in the holes and attach support C with screws (Fig.4a).
3 Place tube A with the extendible part B hanging on the inside, making sure that flange D is
correctly lodged in the support
C (Fig.4a).
4 Next, secure support E to the upper end of the wall, making sure that it is properly aligned with
the extendible tube. Extend the movable part of tube
B until it reaches support E and connect
to the support with the two side screws
F (Fig.4b).
B
E
Fig.4bFig.4a
A
B
E
C
D
F
Fig.4 Assembly of chimney cover