INSTALLATION INSTRUCTIONS USER GUIDE Box Wall Rangehood HC60DCXB3, HC90DCXB3 and HC120DCXB3 models NZ AU ROW
CONTENTS Introduction 3 Safety and warnings 4 Installation instructions 7 Operating instructions 17 Cleaning and maintenance 18 Parts and accessories 20 Manufacturer’s Warranty 21 Customer Care 23 IMPORTANT! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our website www.fisherpaykel.
INTRODUCTION Thank you for purchasing a Fisher & Paykel product. Thousands of hours go into the design, engineering, testing and perfecting of each Fisher & Paykel appliance. The care and attention given to creating these beautiful products doesn’t stop once it has found its home with you.
SAFETY AND WARNINGS ! 13.2 kg WARNING! Weight Hazard The appliance is heavy. Please ensure adequate care is taken when installing the appliance to prevent personal injury. The appliance must be installed onto a solid wall, stud, beam or truss. Weight of the product is 13.2 kg (HC60) / 17.6 kg (HC90) / 24 kg (HC120). (HC60) 17.6 kg (HC90) 24 kg (HC120) ! WARNING! Electric Shock Hazard Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs.
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING! When using this appliance always exercise basic safety precautions including the following: ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● Please read the entire set of instructions before installing or using this appliance. Please make this information available to the person installing the appliance – doing so could reduce your installation costs.
SAFETY AND WARNINGS ●● ●● ●● ●● ●● ●● ●● ●● 6 You must read the details concerning the method and frequency of cleaning. There is a fire risk if cleaning is not carried out in accordance with the instructions. Never leave frying food unattended since grease can overheat and catch fire. The risk of fire is even greater in the case of used oil. Do not flambé under the rangehood. Never use the rangehood without the filters in place.
INSTALLATION INSTRUCTIONS Contents of packaging INSTALLATION INSTRUCTIONS USER GUIDE Box Wall Rangehood HC60DCXB3, HC90DCXB3 and HC120DCXB3 models NZ AU ROW Rangehood (1) Installation instructions User guide manual (1) Chimney (1) Upper chimney (1) Upper chimney bracket (1) Chimney bracket (1) 150 mm diameter ducting adapter (1) Expansion plug (8) 30 mm self tapping screw (8) 10 mm self tapping screw (4) 125 mm ducting adapter (1) 7
INSTALLATION INSTRUCTIONS Product dimensions I Power cord location H ØJ C F G A max A min E B L K 8 D
INSTALLATION INSTRUCTIONS HC60 HC90 PRODUCT DIMENSIONS A Overall height of product HC120 mm 595 – 1035 595 – 1035 595 – 1035 Overall width of product 598 898 1198 C Overall depth of product 500 500 500 D Height of hood 55 55 55 E Height of stainless strip 27 27 27 B F Width of chimney 320 320 320 Depth of chimney 290 290 290 82 82 82 160 160 160 J Diameter of ducting outlet 150 150 150 K Distance between centre of lights 230 230 230 45 45 45 1200 1200 1200
INSTALLATION INSTRUCTIONS Height of rangehood INSTALLATION DIMENSIONS mm M Installation height Ducted externally Recirculation mode min. 635 – max. 1035 min. 675 – max. 1035 N Height top of cooktop to base of product * Electric cooktop (for induction cooktop see note below) Gas cooktop min. 600 – max. 750 min. 650 – max. 750 Rangehood installation height above the cooktop is the user’s preference.
INSTALLATION INSTRUCTIONS Venting options Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. The rangehood can be installed to operate with the exhaust air ducted externally from the kitchen, or installed to operate in recirculation mode with the exhaust air recirculating within the kitchen. Ducted externally For an externally ducted installation it is recommended that 150 mm diameter, rigid or semi-rigid ducting is used.
INSTALLATION INSTRUCTIONS WARNING! ●● ●● ●● This appliance is heavy and requires two persons for unpacking and installation Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards IMPORTANT! Wear gloves to protect against sharp edges.
20 mm INSTALLATION INSTRUCTIONS 250 mm Upper chimney extension bracket attachment points 235 mm Chimney bracket attachment points 250 mm Upper hood attachment points B C Lower hood attachment points D A Fig.2 HC60 HC90 PRODUCT DIMENSIONS HC120 mm A Lower rangehood attachment point width 420 580 900 B Chimney bracket attachment point height 559 559 556 C Upper rangehood attachment point height 286 286 288 D Lower rangehood attachment point height 36 36 42.
INSTALLATION INSTRUCTIONS Fig.3 3 Attach ducting adapter ●● 14 Place the ducting adapter onto the hood and screw it in place using the 10 mm screws.
INSTALLATION INSTRUCTIONS 4 Attach hood to wall ●● Remove filters and air flow balancing plate from hood as shown in Fig.4. Fig.
INSTALLATION INSTRUCTIONS Fig.5 ●● ●● ●● Hang hood off upper hood mounting screws with 2 mm gap. Hang off the keyhole attachment points on the back of the hood (see Fig.5). Tighten screws. Attach lower hood mounting screws to fix hood to wall. Reattach air flow balancing plate and filters. 5 Attach ducting ●● Attach ducting to ducting adapter using aluminium duct tape. 6 Attach chimney ●● ●● ●● Bend the tabs on the chimney (A). Place chimney around the hood chassis and hang off the bracket (B).
OPERATING INSTRUCTIONS Touch control panel CONTROL PANEL FEATURES Filter cleaning alert Activated regularly to alert of the need to clean filters. It can be deactivated with a single press. Timer Turn the timer on. The fan operates for 5 minutes at the current speed and each descending speed before turning off. Lights Turn the lights on or off. The lights are dimmable. Press and hold to progressively adjust the brightness level. Power on/off Turn the rangehood on or off.
CLEANING AND MAINTENANCE WARNING! Unplug or disconnect the appliance from the power supply before servicing or cleaning. IMPORTANT! ●● ●● Never use abrasive or oil based cleaners Wear gloves to protect against sharp edges Maintenance The rangehood should be cleaned regularly using a mild, liquid detergent and a clean soft cloth to avoid a build-up of grease occurring. Avoid the use of corrosive chemicals, abrasive cleaning products, hard brushes and steel wool pads.
CLEANING AND MAINTENANCE WARNING! ●● ●● When replacing the bulb, let the bulb cool, and assure that power to the rangehood has been turned off. Use new bulbs according to that indicated on the rangehood nameplate. Carbon filters – for use in recirculation mode Active carbon filters are disposable items designed to remove grease and odours from cooking vapours before the air is channelled back into the kitchen.
PARTS AND ACCESSORIES ITEM REFERENCE NUMBER LED bulb x2 792556 Aluminium filter with stainless steel cover 792577 Recirculation carbon filter x2 792481 Recirculation diverter 792560 Ducting kit 150 mm (eaves) PD-RHK150E Ducting kit 150 mm (wall) PD-RHK150W 20
MANUFACTURER’S WARRANTY You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this rangehood covering parts and labour for servicing within the country of purchase. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the product, the serial number of which appears on the product, which is found to be defective within TWO YEARS of the date of purchase.
MANUFACTURER’S WARRANTY For Australian Customers This Manufacturer’s Warranty is an extra benefit and does not affect your legal rights. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
CUSTOMER CARE Before you call for service or assistance... Check the things you can do yourself. Refer to your user guide and check that: 1 Your product is correctly installed. 2 You are familiar with its normal operation. If after checking these points you still need assistance or parts, please refer to your nearest Fisher & Paykel trained and supported service technician, Customer Care, or contact us through our website www.fisherpaykel.com.
CUSTOMER CARE *If you call, write or contact us via our website please provide: your name and address, model number, serial number, date of purchase and a complete description of the problem. This information is needed in order to better respond to your request for assistance. Product details can be found on the air flow balancing plate underneath the filters. Registration Register your product with us so we can provide you with the best service possible. To register your product visit our website: www.
www.fisherpaykel.com © Fisher & Paykel Appliances 2016. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your dealer to ensure this booklet correctly describes the product currently available. NZ AU ROW 104118 A 05.
