Owners Manual

12
INSTALLATION INSTRUCTIONS
WARNING!
●
This appliance is heavy and requires two persons for unpacking and installation
●
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
●
Failure to install the screws or fixing device in accordance with these instructions
mayresult in electrical hazards
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1
Prepare for installation.
Before installing your ventilation hood:
●
Please read the instructions carefully.
●
Unpack the ventilation hood and check that all
functions are working.
●
Ensure that the voltage (V) and the frequency (Hz)
indicated on the serial plate match the voltage and
frequency at the installation site.
●
The stainless steel surfaces of the ventilation
hood are very easily damaged during installation
if grazed or knocked by tools. Please take care to
protect the surfaces during installation.
●
Protect the cooktop surface below with cardboard,
or the like, to prevent damage occurring whilst the
ventilation hood is being installed above.
2
Attach ducting adapter and power connection box to
the ventilation hood
●
Place the ducting adapter onto the ventilation
hood and screw it in place using 3/8” (10mm)
screws.
●
Place the power connection box onto the
ventilation hood and screw it in place using 3/8”
(10mm) screws.
●
Follow wiring instructions described in the
‘Electrical connection’ section page15.
3
Provide an opening on the underside of the cupboard
(see product and cabinetry cutout dimensions).
It is also recommended that the cupboard has a door
or service panel that can be easily opened to access
the power connection box
width
depth