BUILT-IN INTEGRATED COOKER HOOD HP90IHCB3 & HP60IHCB3 models INSTALLATION GUIDE / USER GUIDE GB IE
CONTENTS Introduction 3 Safety and warnings 4 Installation Instructions 7 About your cooker hood – Energy efficiency 15 Operating instructions 16 Cleaning and maintenance 17 Parts and accessories 18 Manufacturer’s Warranty 19 Customer Care IMPORTANT! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time.
INTRODUCTION Thank you for purchasing a Fisher & Paykel product. Thousands of hours go into the design, engineering, testing and perfecting of each Fisher & Paykel appliance. The care and attention given to creating these beautiful products doesn’t stop once it has found its home with you.
SAFETY AND WARNINGS ! 10kg (HP60) 11.5kg (HP90) WARNING! Weight Hazard The cooker hood is heavy. Please ensure adequate care is taken when installing the cooker hood to prevent personal injury. The cooker hood must be installed onto a solid wall, stud, beam or truss. Weight of the product is 10kg (HP60) / 11.5kg (HP90) ! WARNING! Electric Shock Hazard Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs.
SAFETY AND WARNINGS • • • • • • • • appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. The installation of Fisher & Paykel cooker hoods must comply with the information in this guide. Failure to install the cooker hood in accordance with these installation instructions may result in electrical hazards, injury, and damage to your appliance and loss of warranty.
SAFETY AND WARNINGS • If the supply cord of this equipment is damaged it must only be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. • Always switch the power off prior to installation, servicing or cleaning the cooker hood. • Never use the cooker hood without the filters in place. • Stainless steel or powdercoat is very easily damaged during installation if abraded or knocked by tools.
INSTALLATION INSTRUCTIONS Contents of packaging BUILT-IN INTEGRATED COOKER HOOD HP90IHCB3 & HP60IHCB3 models INSTALLATION GUIDE / USER GUIDE GB IE Cooker hood (1) 125mm ducting adapter (1) Installation instructions User guide manual (1) 150mm ducting adapter with non return flap (1) 13mm screw (2) 7
INSTALLATION INSTRUCTIONS Product and cabinetry cutout dimensions K J ØL Power cord location H Ducting adapter I (A) A O D G F E C B M N N M HP60 8 HP90
INSTALLATION INSTRUCTIONS HP60 PRODUCT DIMENSIONS A Overall height of product HP90 mm 350 (395) 315 (360) B Overall width of product 530 830 C Overall depth of product 280 280 2 2 (with ducting adapter) D Thickness of flange E Width of chassis 492 792 F Depth of chassis 255 255 G Height of side of chassis 120 120 H Width of top surface of chassis 220 220 I Length of angled surface of chassis 260 335 J Distance from centre of ducting outlet 145 145 K Distance from centre of du
INSTALLATION INSTRUCTIONS Height of cooker hood MINIMUM CLEARANCES P Height top of hob to base of product * Electric hob (for induction hob see note below) Gas hob mm min. 600 – max. 750 min. 650 – max. 750 Cooker hood installation height above the hob is the user’s preference. This cooker hood must be installed between the minimum and maximum height limits indicated in the table above. Installation at the minimum height limit will improve the efficiency of capturing cooking odours, grease and smoke.
INSTALLATION INSTRUCTIONS Venting requirements IMPORTANT! To reduce risk of fire and to properly exhaust air, be sure to duct air outside — Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. The range hood can be installed to operate with the exhaust air ducted externally from the kitchen or with the exhaust air recirculating within the kitchen. External venting ●● ●● For best results: Use the shortest and straightest duct route possible.
INSTALLATION INSTRUCTIONS IMPORTANT! Venting directly into the cabinet with no ducting and louvered vent is not permitted. To recirculate your perimeter insert range hood: 1 Determine the desired location of the 150mm louvered vent on your cabinetry. The louvered vent can be placed on the side or front of your cabinet provided there is sufficient clearance from the surrounding cabinetry to enable ventilated air to recirculate back into your kitchen.
INSTALLATION INSTRUCTIONS 2 1 3 4 A A A A A B BB B B 360˚ 360˚ 360˚ 360˚ 360˚ 360˚ 5 6 C C C C C 13
INSTALLATION INSTRUCTIONS 5 Lift the cooker hood and fit through the opening of the cupboard till the spring loaded brackets / clips hold the product in place. x4 6 Secure cooker hood while tightening the 4 brackets / clips. x4 2.3 2.1 width 2.2 depth 7 Connect duct and plug cooker hood in.
ABOUT YOUR COOKER HOOD – ENERGY EFFICIENCY Product Fiche EN61591 MODEL Annual Energy Consumption (kWh/annum) Time Increase Factor Energy Efficiency Index Energy Efficiency Class Fluid Dynamic Efficiency Fluid Dynamic Efficiency Class Lighting Efficiency Lighting Efficiency Class Grease Filtering Efficiency Grease Filtering Efficiency Class HP60IHCB3 HP90IHCB3 32.2 1 52.8 A 28.5 A 16.1 C 91.2 B Airflow at Min. Speed (m³/hr) 200 Airflow at Max.
OPERATING INSTRUCTIONS Touch control panel CONTROL PANEL FEATURES Power on/off Turn the cooker hood on or off. The fan automatically turns on to operate at level 1. Fan speed 1–4 Adjust the fan speed levels from 1 – 4 with 1 being the lowest level and 4 being the highest. The fan speed level icon illuminates red when selected. Boost Turn the fan onto boost speed. The icon flashes red when it is on. The cooker hood will operate on boost speed for 5 minutes and will then revert to speed 4.
CLEANING AND MAINTENANCE IMPORTANT! Never use abrasive or oil based cleaners General maintenance Before performing any cleaning or maintenance on your cooker hood, ensure that the power supply is switched off to the hood. The cooker hood should be cleaned regularly using a mild, liquid detergent to avoid a build up of grease occurring. Grease deposits are corrosive which can cause damage to your cooker hood.
PARTS AND ACCESSORIES ITEM 18 REFERENCE NUMBER LED bulb x2 792556 Aluminium filter 792429 Recirculation carbon filter x2 792481
MANUFACTURER’S WARRANTY You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this Built-in integrated cooker hood covering parts and labour for servicing within the United Kingdom and Ireland. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the product, the serial number of which appears on the product, which is found to be defective within TWO YEARS of the date of purchase.
CUSTOMER CARE Before you call for service or assistance... Check the things you can do yourself. Refer to your user guide and check that: 1 Your product is correctly installed. 2 You are familiar with its normal operation. If after checking these points you still need assistance or parts, please refer to your nearest Fisher & Paykel trained and supported service technician, Customer Care, or contact us through our website fisherpaykel.com.
CUSTOMER CARE Complete and keep for safe reference: Model Serial No.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2018. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. GB IE 104040D 08.
