INSERT RANGE HOOD HPB3011-4, HPB3011-6, HPB3019-6, HPB3611-4, HPB3611-6, HPB3619-6, HPB3619-12 & HPB4819-12 models INSTALLATION GUIDE US CA 105305B 02.
1 2 SAFETY AND WARNINGS PRODUCT INFORMATION EN FP Pro Hood Fasteners ! WARNING! ●● ●● Weight Hazard ●● The appliance is heavy. Please ensure adequate care is taken when installing the appliance to prevent personal injury. ¾” OD x 3/16” ID Flat Washer #10-32 Pan Head Pozi Drive Wall Plug Please read this manual carefully, and keep it after installation for future reference. Keep all packing materials (box, pallet, straps) until the unit has been inspected.
3 PRODUCT AND CABINETRY CUT-OUT DIMENSIONS HPB3011-4, HPB3011-6, HPB3019-6, HPB3611-6, HPB3619-6, HPB3619-12 and HPB4819-12 models C R S D L 1 1/2” (38mm) U M T G H K I N O A Q B E J Refer to page 4 for details on ‘Cabinet mounting installation’ c F P D 2
3 PRODUCT AND CABINETRY CUT-OUT DIMENSIONS PRODUCT DIMENSIONS EN HPB3011-4 HPB3011-6 HPB3019-6 HPB3611-4 HPB3611-6 HPB3619-6 HPB3619-12 HPB4819-12 inches (mm) inches (mm) inches (mm) inches (mm) inches (mm) inches (mm) 16 1/4 (412) 16 1/4 (412) 16 1/4 (412) 16 1/4 (412) 18 3/16 (462) 18 3/16 (462) 16 (407) 16 (407) 16 (407) 16 (407) 16 (407) 16 (407) A Overall height of product B Overall height of product (excluding duct adaptor) C Overall width of product 28 3/4 (730) 28
4 INSTALLATION PREPARATION IMPORTANT Range hood height The HPB3011-4, HPB3011-6, HPB3611-4 and HPB3611-6 models are not suitable for use with a high powered professional style cooktops. A Range hood width ●● ●● ●● INSTALLATION DIMENSIONS The range hood width is recommended to be no less than the width of the cooktop. A wider range hood can be used to increase the capture area if space is not restricted. The range hood should ideally be centered above the cooktop for proper performance.
4 ●● ●● INSTALLATION PREPARATION Electrical requirements Venting requirements WARNING! IMPORTANT! To reduce risk of fire and to properly exhaust air, be sure to duct air outside — Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. Electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. This unit must be grounded/earthed.
5 INSTALLATION INSTRUCTIONS IMPORTANT! Venting directly into the cabinet with no vent is not permitted. WARNING! ●● ●● ●● ●● This appliance is heavy and requires two persons for unpacking and installation. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards.
5 INSTALLATION INSTRUCTIONS D C EN E Note: The range hood must be installed with the control panel on the right.
6 8 WIRING DIAGRAM
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. US CA 105305B 02.
