INTEGRATED RANGEHOOD HPB6028-1, HPB7528-1, HPB7548-1, HPB9028-1, HPB9048-1, HPB9048-2 & HPB12048-2 models INSTALLATION GUIDE NZ AU ROW
1 2 SAFETY AND WARNINGS PRODUCT INFORMATION FP Pro Hood Fasteners ! WARNING! ●● ●● Weight Hazard ●● The appliance is heavy. Please ensure adequate care is taken when installing the appliance to prevent personal injury. ¾” OD x 3/16” ID Flat Washer Weight of the products are: #10-32 Pan Head Pozi Drive Wall Plug Please read this manual carefully, and keep it after installation for future reference. Keep all packing materials (box and straps) until the unit has been inspected.
3 PRODUCT AND CABINETRY CUT-OUT DIMENSIONS HPB6028-1, HPB7528-1, HPB7548-1, HPB9028-1, HPB9048-1, HPB9048-2 and HPB12048-2 models C L D 38mm s r M G H K I N O Q B E J C F P D 2 A Refer to page 4 for details on ‘Cabinet mounting installation’
3 PRODUCT AND CABINETRY CUT-OUT DIMENSIONS HPB6028-1 PRODUCT DIMENSIONS HPB7528-1 HPB7548-1 HPB9028-1 HPB9048-1 HPB9048-2 HPB12048-2 mm mm mm mm mm mm mm 407 407 407 407 407 462 462 381 381 381 381 381 381 381 A Overall height of product B Overall height of product (excluding duct adaptor) C Overall width of product 580 730 730 880 880 880 1180 D Overall depth of product 280 280 480 280 480 480 480 E Thickness of flange 2.5 2.5 2.5 2.5 2.5 2.5 2.
4 INSTALLATION PREPARATION IMPORTANT Rangehood height Rangehood width ●● ●● ●● ●● INSTALLATION DIMENSIONS The smaller rangehood models are only intended to be installed over a cooktop with a maximum of four burners or cooking zones. The rangehood width is recommended to be no less than the width of the cooktop. A wider rangehood can be used to increase the capture area if space is not restricted. The rangehood should ideally be centred above the cooktop for proper performance.
4 ●● ●● ●● ●● ●● ●● ●● ●● INSTALLATION PREPARATION Electrical requirements Venting requirements WARNING! IMPORTANT! Electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. Turn off electricity at the service panel before wiring the unit. A 230 volt, 50Hz AC-only electrical supply is required. This unit must be earthed/grounded. Earthing/Grounding instructions: This appliance must be grounded.
5 INSTALLATION INSTRUCTIONS IMPORTANT! Venting directly into the cabinet with no vent is not permitted. WARNING! ●● ●● ●● ●● This appliance is heavy and requires two persons for unpacking and installation. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards.
5 INSTALLATION INSTRUCTIONS D C E Note: The rangehood must be installed with the control panel on the right.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this document correctly describes the product currently available. NZ AU ROW 105464B 09.
