INSTALLATION INSTRUCTIONS USER GUIDE Built-in Slideout Rangehood HS60XW4, HS60LXW4, HS60LRX4 and HS90X4 models NZ AU
CONTENTS Safety and warnings 3 Installation instructions 5 Operating instructions 10 Cleaning and maintenance 11 Parts and accessories 13 Manufacturer’s Warranty 14 Customer Care 16 IMPORTANT! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard All electrical work must be done in accordance with local and/or national electrical codes as applicable. If you are unfamiliar with methods of installing electrical wiring, employ the services of a qualified electrician. Turn off power at service entrance before installing wiring or servicing this product. ! 11.2 kg (HS90X4) WARNING! Weight Hazard The rangehood is heavy.
SAFETY AND WARNINGS ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● 4 Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. Before connecting any pipes, consult municipal ordinances to ensure that any applicable regulations concerning the discharge of exhaust air are adhered to and request permission from the person in charge of the building.
INSTALLATION INSTRUCTIONS Contents of packaging INSTALLATION INSTRUCTIONS USER GUIDE Built-in Slideout Rangehood HS60XW4, HS60LXW4, HS60LRX4 and HS90X4 models NZ AU Rangehood (1) Installation instructions User guide manual (1) Screw M6 x 40 mm (incl.
INSTALLATION INSTRUCTIONS Product dimensions Power cord D C F A B E HS60LRX4 HS90X4 HS60XW4 HS60LXW4 mm mm mm 180 180 180 B Overall width of product 598 898 598 C Overall depth of chassis 280 280 280 D Overall depth of chassis (fully extended) 460 460 460 PRODUCT DIMENSIONS A Overall height of product E Height of handle F Installed chassis height Power cord length IMPORTANT! 70 40 40 140 140 140 1500 1500 1500 Actual product dimensions may vary by ± 2 mm.
INSTALLATION INSTRUCTIONS Height of rangehood Please read the entire instructions BEFORE installing the rangehood. ●● ●● ●● Ascertain the desired installation height of the rangehood. When installing the rangehood, the lower edge of the unit must be a minimum of 600 mm above electric cooktop surface; 650 mm above gas cooktop cooking surface; and up to a maximum of 750 mm. Any installation above 750 mm will compromise the extraction performance.
INSTALLATION INSTRUCTIONS Venting options Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. Ducted We recommend rangehoods be vented outside, recirculating installation is recommended only when vented installation is not possible. For optimal efficiency, use smooth-walled ducting. Flexible ducting should only be used as last resort; it may reduce performance and increase noise. ●● ●● We recommend to use top extraction for venting.
INSTALLATION INSTRUCTIONS WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. A Installation 1 Preparing the rangehood for installation: Fig.1 Preparing for install ●● ●● ●● ●● ●● ●● ●● ●● ●● ●● Before commencement, unpack the rangehood and check that it functions correctly. Ø125 - 130 mm Ensure the overhead cabinets are built according to the minimum clearances table on page 7.
OPERATING INSTRUCTIONS Control panel features Left hand side Right hand side Light switch: the light can be operated independently from the fan. Fan switch: the fan can be run at different speeds depending on the cooking requirements. Fig.5 Light switch Fig.6 Fan switch Operating instructions 1 Pull out the front panel more than 50 mm. The front panel has to be pulled to its maximum extension so as to optimise the extraction capacity. 2 Switch on the lamps (Fig.5).
CLEANING AND MAINTENANCE WARNING! Unplug or disconnect the appliance from the power supply before servicing or cleaning. IMPORTANT! ●● ●● Never use abrasive or oil based cleaners. Wear gloves to protect against sharp edges. General maintenance The manufacturer is not liable for any damage caused by not following these instructions. The rangehood should be cleaned regularly using warm water with soap or mild liquid detergents.
CLEANING AND MAINTENANCE WARNING! When replacing the bulb, let the bulb cool, and assure that power to the rangehood has been turned off. Use new bulbs according to that indicated on the rangehood nameplate. Carbon filter for all recirculating installations (Optional: HS60LXW4, HS60XW4, HS90X4) (With product: HS60LRX4) Active carbon filters are disposable items designed to remove grease and odours from cooking vapours before the air is channelled back into the kitchen.
PARTS AND ACCESSORIES ACCESSORY PART NUMBER Replacement aluminium filter x2 (HS60) 792391 Replacement aluminium filter x2 (HS90) 792392 Recirculation charcoal filter x2 792390 Halogen bulb 792461 Ducting kit 125 mm (eaves) PD-RHK125E Ducting kit 125 mm (wall) PD-RHK125W Ducting kit 125 mm (roof) PD-RHK125T 13
MANUFACTURER’S WARRANTY You automatically receive a 2 year Manufacturer’s Warranty with the purchase of this Slideout rangehood covering parts and labour for servicing within the country of purchase. Fisher & Paykel undertakes to: Repair or, at its option, replace without cost to the owner either for material or labour any part of the product, the serial number of which appears on the product, which is found to be defective within TWO YEARS of the date of purchase.
MANUFACTURER’S WARRANTY For Australian customers This Manufacturer’s Warranty is an extra benefit and does not affect your legal rights. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
CUSTOMER CARE Before you call for service or assistance... Check the things you can do yourself. Refer to your user guide and check that: 1 Your product is correctly installed. 2 You are familiar with its normal operation. If after checking these points you still need assistance or parts, please refer to your nearest Authorised Service Centre, Customer Care, or contact us through our website www.fisherpaykel.com.
CUSTOMER CARE Complete and keep for safe reference: Model Serial No.
© Fisher & Paykel Appliances 2015. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. NZ AU 104032 A 10.