Manualshelf

Installation guide

ManualsBrandsFisher & Paykel ManualsWasherOfficial Fisher & Paykel washer
12
NOTETOTHEINSTALLER
Afteryou havefollowedtheprocedureson
thepreviouspages. Checkthefollowing.
REMOVE TRANSIT
BO'I'rOM PACKER
Bottompacker MUST be removed
from the base of the washer, before
the basket packer is removed.
LEVELING
Make sure washer is level and
four rubber insertsare properly
installed.
ADJUSTABLE FEET
_m RUBBER INSERT _'_
DRAIN HOSE
PULL HOSE
THROUGH
GUIDE m
3/4"
(20mm)
The drain hoseguide MUST be
fitted to the drain hose and should
not extend more than 3/4" (20mm)
from the end of the guide. Place
the drain hose in tub or standpipe.
GROUNDING
MUST be properly grounded to
conform to local codes and
ordinances.
WARNING: Improperconnection of
equipment-groundingconductor can
resultin a riskof electricshock. Check
with a qualifiedelectricianor
servicemanif you are indoubt as to
whethertheapplianceisproperly
grounded.
INLETHOSE
CONNECTIONS
Faucet
end of
hose
Filter end must
be connected
to faucet.
Washer
end of
hose.
OPERATION
1.Turnfaucets on. Check for leaks,
noise, vibration, correct water
temperatures and proper
operation in spin.
2.Turn hotand cold water faucetsoff
and instructcustomer to do the
same when washer is not in use.
3. Give customer the Use& Care
Book and Installation Instructions.
INSTALLATION REQUIREMENTS
LOCATION
Washer must be installed on firm
flooring to minimize vibration during
spin cycles. Concrete flooring is
best, but wood base is sufficient
providing floor support meets FHA
standards.
Washer should not be installed on
rugs or exposed to the weather.
PLUMBING
Water Temperature
Your cold water should not exceed
95°F (35°C) or your hot water exceed
150°F (65°C). Temperaturesabove
this may damage your washer.
Shut off valves
Both hot and cold shut-off valves
(faucets) should be available in
laundry area.
Drain
Water may be drained into a
standpipe or set tub. The standpipe
must be 11/2" (38mm) minimum
inside diameter and must be open to
the atmosphere.
ELECTRICAL
This appliance must be supplied with
110V-120V, 60Hz, and connected
to an individual, properly grounded
branch circuit, protected by a 15 or
20 amp circuit breaker or time
delay fuse.
SPECIFICATIONS
Lid Clearance
Washer
end of
hose
_ Faucet
end of
hose
Standpipe Height
33 1/2" to 78"
HEIGHT
! I
Allowfo_
adjustablee//
DEPTH
DIMENSIONS
WIDTH
/
Inlet water pressure /
Max 150 psi (1MPa)
J
Min 3 psi (20kPa)
MODEL All models
DEPTH 251/2" (650mm)
WIDTH 251/2" (650mm)
HEIGHT to top of console 401/2 "- 411/2" (1020-1050mm)
HEIGHT LID OPEN 551/2 "- 561/2" (1410-1440mm)
Specification subject to change without notice P/N 420264A Specificationsubjectto change without notice

Summary of content (2 pages)