Installation Guide

9
OVEN INSTALLATION
This oven cannot be properly installed without referring to the mounting instructions found on
both templates.
Read and follow mounting information on both
TOP CABINET TEMPLATE and WALL TEMPLATE.
MOUNTING PLATE
Step
1
A
C
C
B
C
C
Power Supply Cord Hole
House Duct
Mounting Plate
Figure 18
Setup position
z
Draw a line down the middle of the studs.
See the Wall Construction, page 4.
z
Draw a vertical line on the wall at the
center of the 30 in wide space.
See Figure 18.
Note: Use the
WALL TEMPLATE for the rear
wall. Reference WALL TEMPLATE prior to
proceeding. Installation of this product
requires 2 people.
Step
2
Drilling
Reference the
WALL TEMPLATE.
Step
3
Mounting plate
Figure 19
Tightening the screws
To attach the mounting plate to the wall
using the toggle bolt assemblies and/or lag
screws:
z
Insert toggle bolts through the mounting
plate at required locations and add the
spring loaded toggles. See Figure 19.
Ensure you leave space at least the
thickness of the wall between the
mounting plate and the end of the toggle
nut, (in closed position). If you do not
leave this space, the toggle nut will not
open on the other side of the wall.
Dry Wall
Space more than
wall thickness
Figure 20
z
Position mounting plate on wall and
insert toggle bolt assemblies through the
drywall holes or start the lag-screw(s)
through the wall stud(s). See Figure 20.
Figure 21
z
Secure the mounting plate to the wall by
tightening the toggle bolt assemblies or
lag screw(s). See Figure 21.
z
Drill
3
⁄16 in (4.7 mm) diameter lag screw
hole(s), into one or more wall studs.
You must have at least one lag screw into
a wall stud. For stud location refer to Wall
Construction.
z
Tighten the lag screw(s) into wall stud(s).