Installation Guide
Table Of Contents
- User/Installation Guide
- Contents
- Safety and warnings
- Installation instructions
- Before your first wash
- Safety features
- Control panel
- Wash cycles
- Wash preparation
- Getting started quickly
- Wash options
- Favourite cycle
- Customising wash cycles
- Changing pre-set options
- Caring for your washer
- Before you call for service
- Fault codes
- Troubleshooting
- Manufacturer’s warranty
- Customer care
INSTALLATION INSTRUCTIONS
6
INSTALLATION INSTRUCTIONS
Accessories
Check if you received the following accessories with your Fisher&Paykel washer. Youwill
find them inside the drum or attached to the packaging.
z
1 x hose guide
z
2 x inlet hoses
Unpacking
To ensure the best performance from your new washer please follow the instructionsbelow.
Removing the packaging
1 Remove the outer packaging.
2 Tilt the washer backwards and walk it off the base
packer one foot at a time (ensure the lid is still
taped down).
3 Remove the base packer from under the washer
by tilting the washer backwards and pulling the
packer out the front.
4 Remove the tape, lift the lid and remove the bowl
packer from the bowl.
5 Remove the hoses and accessories.
6 Keep the base packer and bowl packer in case
they are required for future transit.
Ensure that the base packer has been removed before operating your washer.