Guide D'Installation

2
WARNING!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
z
Save these instructions for the local inspectors use.
z
Please make this information available to the person installing the appliance — doing so
could reduce your installation costs.
z
This oven is to be installed and connected to the electricity supply only by an
authorized person.
z
If the installation requires alterations to the domestic electrical system, call a qualified
electrician. The electrician should also check that the socket cable section is suitable
forthe electricity drawn by the oven.
z
The oven must be grounded.
z
Installation must comply with your local building and electricity regulations.
z
This appliance must be installed and connected to the mains power supply only by a
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
z
If the power supply cable is damaged, it must be replaced by the manufacturer,
itsservice agent or similarly qualified person in order to avoid a hazard.
z
A circuit breaker is recommended.
z
Do not use adaptors, reducers or branching devices to connect the oven to the mains
electricity supply, as they can cause overheating and burning.
z
Ensure the cavity is completely sealed with no gaps. This is to ensure the oven cooling
system functions correctly.
z
The appliance must not be installed behind a decorative door in order to avoid overheating.
Electrical requirements
z
Connect oven with copper wire only.
z
Do not cut the conduit.
z
A U.L. listed conduit connector must be provided at the junction box.
z
Do not ground to a gas pipe.
z
Do not have a fuse in the grounding or neutral circuit.
z
Fuse both sides of the line.
z
A time delay fuse or circuit breaker is recommended. If using a time delay fuse,
thenfuse both sides of the line.
z
Flexible armored cable from the appliance should be connected directly to the junction box.
z
Connect directly to the fused disconnect (or circuit breaker box) through flexible,
armored or non-metallic sheathed, copper cable (with grounding wire).
z
If codes permit and a separate grounding wire is used, it is recommended that
a qualified electrician determine that the grounding path and wire gauge are in
accordance with local codes.
SAFETY AND WARNINGS
!
WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Before carrying out any work on the electrical
section of the appliance, it must be disconnected
from the mains electricity supply.
• Connection to a good earth wiring system is
absolutely essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
!
WARNING!
Fire Hazard
Failure to follow this advice may result in
overheating, burning, and injury.
• Do not use adapters, reducers, or branching
devices to connect this appliance to the mains
power supply.
!
WARNING!
409 lb
186 kg
242 lb
110 kg
Very Heavy
Failure to follow this advice may result in
serious injury.
• Do not attempt to lift this product unassisted.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country,
please go to our website www.fisherpaykel.com or contact your local Fisher&Paykel dealer.
!
WARNING!
Cut Hazard
Failure to use caution could result in injury.
• Take care – some panel edges are sharp.