Planning Guide - Minimal and Contemporary Triple Stack Install

CABINETRY DIMENSIONS
0" Triple Stack
575mm
SIDE ELEVATION
with front panels
FRONT ELEVATION
without front panels
SIDE ELEVATION
without front panels
1444mm
Rebate for front
trim of Oven and
Companion Trim Kit
to achieve flush finish
SEALED CAVITY
22 5/8"
56 7/8"
IMPORTANT NOTE:
MINIMUM and CRITICAL dimensions are stated to meet product installation requirements
and compliance standards. Where these dimensions are not adhered to product safety and
performance may be compromised, along with undesirable fit in cabinetry.
952mm
7 1/2"
480mm
18 7/8"
12mm
1/2"
681mm
26 1/16"
117mm
46 /16"
724mm
28 1/2"
762mm
0"
560mm
22 1/16"
CRITICAL
617mm
24 5/16"
1444mm
56 7/8"
50mm
2"
271mm
10 11/16"
MINIMUM
MAXIMUM
MINIMUM
MINIMUM
RECOMMENDED MINIMUM
42mm
1 5/8"
CRITICAL
Distance between
cabinetry front panels
Height of rebte
for Oven nd
Coffee Mker or
Cook Product
with Trim Kit
Height of
Drawer chassis
Depth clearance for Oven chassis
Height
clearance for
Oven chassis
MINIMUM
Height clearance
for Coffee
Maker or Cook
Product with
Trim Kit. Allows
2mm clearance
above.
Ventilation of 2” x 22 1/16”
(50mm x 560mm) or totalling
4.4in
2
(280cm
2
) is required
for Coffee Maker and Cook
Products. The air vent must be
located at the rear of cabinet, it
can be positioned at the base,
top, sides, or back.
MINIMUM
AIR VENT
Shelf height
to achieve
mm between
products
20mm
1/16"
Front panel
thickness.
Alternate
thickness can
be used
Ensures the Oven cooling
system functions correctly.
Width clearance for Oven chassis
Overall cabinet width
Width between additional sidewalls
Overall depth of front panel and cavity
Combined
height
clearance for
Oven chassis
and Drawer
chassis
MINIMUM
MINIMUM
Overall cavity
height between
top and bottom
shelves
ADDITIONAL SIDE WALL
760mm
29 15/16"
RECOMMENDED
Front panel width
FRONT PANEL