BUILT-IN OVEN OB60SDPT models INSTALLATION GUIDE NZ AU GB IE 591942A 07.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply. • Connection to a good earth wiring system is absolutely essential and mandatory. • Alterations to the domestic wiring system must only be made by a qualified electrician.
PARTS SUPPLIED Screws (2) Metal side shelves fixing nut (2) PRIOR TO INSTALLATION Ensure that: the countertop and oven cavity are square and level, and are the required dimensions the installation will comply with all clearance requirements and applicable standards and regulations the isolating switch will be easily accessible to the customer with the oven installed the electrician provides sufficient free length of power supply cable to reach from the bottom rear of the cavity to at least 1.
PRODUCT DIMENSIONS a d FRONT PROFILE h e PRODUCT DIMENSIONS f c PLAN 4 MM A Overall height of oven 598 B Overall width of oven 596 C Overall depth of oven (excluding handle and dials) 565 D Height of chassis 575 E Width of chassis 556 F Depth of chassis 545 G Depth of oven frame and control panel (distance between front of chassis and front of oven door, excl.
CABINETRY DIMENSIONS PROUD INSTALL b e c a 16-20mm d PROFILE PLAN FLUSH INSTALL CABINETRY DIMENSIONS OB60SDPT MODELS MM A Minimum inside width of cavity 560 B Overall width of cabinetry 600 C Minimum inside height of cavity 580 D Overall height of cabinetry 600 E Minimum inside depth of cavity 550 If installing a cooktop above the oven, ensure adequate clearance is provided as per the cooktop manufacturer’s instructions.
DISCARD PACKAGING RESPONSIBLY Remove the accessories box from the top of the oven and set aside.
CONNECT THE OVEN TO THE MAINS SUPPLY IMPORTANT! zz zz This oven must be connected to the mains power supply only by a suitably qualified person. This oven must be earthed. Ensure cable clamp is tightened L1 N(L2) L1 E N(L2) E Before connecting the oven to the mains power supply, check that: the domestic wiring system is suitable for the power drawn by the oven (as specified on the rating plate) Unclip and lift the voltage corresponds to the value given on the rating plate.
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER TEST OPERATION: Ensure the oven is level and securely fitted to the cabinetry. Turn the power to the oven on. The display should light up. Set the clock following the instructions in the ‘User guide’. Check the lower trim is undamaged. Open the oven door slowly until it is fully open and check there is adequate clearance between the bottom of the door and the lower trim. Set the oven to Bake at 50oC.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. NZ AU GB IE 591942A 07.