BUILT IN OVEN OB90 models INSTALLATION GUIDE NZ AU GB IE 591672B 11.
1 SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING ! Electrical shock hazard Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs. Connection to a good earth wiring system is essential and mandatory. Alterations to the domestic wiring system must only be made by a qualified electrician. Failure to follow this advice may result in electrical shock or death. z z z WARNING ! Cut Hazard Take care ā panel edges are sharp.
2 PRIOR TO INSTALLATION Before you install the oven, make sure: z z z z z z z it will be lifted by two people. the oven will rest on a flat surface that can support its weight. the benchtop and oven cavity are square and level, and are the required dimensions. the height from the floor suits the customer. the oven door can open fully without obstruction.
PRODUCT DIMENSIONS g B D A e f C h i FRONT D TOP j SIDE OB90 MODELS PRODUCT DIMENSIONS A Overall height of product (including upper and lower vents) 478 B Overall width of product 895 C Depth of oven front and control panel (excluding handle, dials and stainless steel cap) 3 (MM) 20 D Depth of oven chassis (excluding oven front) 544 E Height of chassis 468 F Height of chassis at the rear 463 G Overall width of chassis 853 H Width of door (includes stainless steel cap) 784 I
CABINETRY DIMENSIONS M N L Electrical supply 16-20 mm K min. 2.5 mm IMPORTANT! SIDE TOP Make sure the oven is installed in a cavity that is completely sealed on all sides (including top and base). This is to ensure the oven cooling system functions correctly.
DISCARD PACKAGING RESPONSIBLY ! 124 lb 56 kg IMPORTANT! WARNING! When you remove the oven from the carton be careful not to damage the lower trim. The trim is important for both ventilation and to ensure the door opens fully without obstruction Very Heavy Do not attempt to lift this product unassisted. Lifting unassisted may cause serious injury. Remove the accessories box from the top of the oven and set aside. Oven may vary.
8 CONNECT THE OVEN TO THE MAINS SUPPLY IMPORTANT! z z This oven must be connected to the mains power supply only by a suitably qualified person. This oven must be earthed. MODEL OB90 MAX POWER (W) VOLTAGE (V) AMPS (A) 4730 220 ā 240 V~ 20.56 Before connecting the oven to the mains power supply, check: z z the domestic wiring system is suitable for the power drawn by the oven (as specified on the rating plate) the voltage corresponds to the value given on the rating plate.
9 SECURE THE OVEN TO THE CABINETRY IMPORTANT! z Take care not to damage the upper trim of the oven or the door sensor lever. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher & Paykel will not cover the cost of removing the oven, or damage caused by this removal. 1 2 3 4 Position the oven in the prepared cavity. Lift from both sides placing hands under the oven chassis.
!1 TROUBLESHOOTING IF THE APPLIANCE IS NOT FUNCTIONING CORRECTLY AFTER INSTALLATION CHECK THE FOLLOWING: F That the circuit breaker has not tripped or the fuse blown. F Make sure that the electrical connections have been correctly made. F Make sure that power is being supplied to the oven. F Make sure the voltage is correct across all phases. F If a problem occurs, consult the Troubleshooting section of the User Guide.
!2 FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER: F Make sure the oven is level and securely fitted to the cabinetry and the oven door opens and closes freely. F Make sure all the internal packaging has been removed from the oven cavity. F Make sure all oven vents and openings are clear and are free of any obstruction/damage. IMPORTANT! Failure to make sure all oven vents are clear may result in poor product performance. F Make sure the isolating switch is accessible by the customer.
FISHERPAYKEL.COM Ā© Fisher & Paykel Appliances 2018. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. NZ AU GB IE 591672B 11.
