Installation Guide
7
9SECURE THE OVEN TO THE CABINETRY
!0REFIT THE DOOR
IMPORTANT!
z
Take care not to damage the upper trim of the oven or the door sensor lever.
z
Do not over-tighten the screws.
z
Do not seal the oven into the cabinetry with silicone or glue. This makes future
servicing difficult. Fisher & Paykel will not cover the cost of removing the oven, or
damage caused by this removal.
1 Position the oven in the prepared cavity.
2 Lift from both sides placing hands under the oven chassis.
3 Push oven in, ensuring you’re not pushing on the vents or control panel.
4 Secure oven to cabinetry using supplied screws.
1 Hold the door firmly and insert the hinge tongues
into the slots on either side.
2 Ensure that the notices on both sides drop into the
places shown before opening the door to its full extent.
3 Fully close the levers on the left and right hinges.
4 Close the door and check that it is properly in place;
itshould sit square to the oven vent louvres and the
control panel.
Notch