User Guide

16
USING YOUR OVEN
Fitting the side racks and catalytic panels
1 Remove all shelves and trays.
2
For easier access to the fixing screws,
you may remove the oven door first. See
‘Removing and refitting the oven door.’
3
Using a small coin or a flat-head screwdriver,
loosen and remove the front fixing screw
(the back lock stud cannot be removed), as
shown.
4
Remove the side rack.
5 Fit the catalytic panel. When fitting the side
catalytic panels, make sure that:
●
you slide the panel in, with the cutout in
the panel fitting behind the back lock stud.
●
the arrows are pointing upwards
●
the panel with the round hole is on the
right oven wall.
6
Refit the side racks.
●
Slide the side rack gently so it engages
with the rear lock stud.
●
Make sure that they are the right way up,
as in the illustrations, and then insert and
tighten the front fixing screw.
7 If not already fitted, fit the telescopic sliding
shelf supports. See “Care and cleaning’ for
instructions.
Left hand
side panel